Model #137218100 CRAFTSMAN Saw Table

  • Table
    3 Results
  • Base Assy
    3 Results
  • Motor Assy
    3 Results
Find part by diagram >

Question and Answers

Q:

parallel bracket assembly 137218100

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your saw and I do understand your frustration. Glad to help out. I'm looking at your model number 137218100 and parallel bracket and the handle are separate items. The parallel bracket assembly is 26fm and the handle is 0b6s. I have included a link to our Parts Direct page where you can purchase the part you need to complete your repair. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
December 20, 2014
Q:

my craftsman table saw will not start

A:

I am sorry that you are having some difficulties with your table saw and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
February 16, 2013
A:

Thank you for your question. I am sorry you are having a problem with the saw. It is unusual for a saw to stop working after it was tipped. I suspect the switch or reset has saw dust in it. When you tipped the saw the saw dust settled between the contacts and will not close when turned on. I recommend removing the switch and try to blow the dust out with compressed air. The put it back in and check the operation. If it still does not work I recommend checking the continuity with an ohmmeter. If you need to order a new switch you can do so from the following link. <a href="http://www.searspartsdirect.com?MML=MMLxexpertxmerch" target=_blank'>Craftsman table saw parts</a>    I hope this is helpful. Please let me know if you need further assistance.  Mark   

Read More
Mark T -
Sears Technician
February 18, 2013
See more answers
Q:

Model #137218100 - Craftsman Table saw

A:

If it's the brushes, how easy are they to replace on this model?

Read More
Anonymous -
June 20, 2012
A:

Your details do indicate that you have a problem with the motor. Replacing those brushes may fix your problem. You can order the brushes from this page: Brush Assembly for Craftsman Table Saw 137.218100 . Be sure that you unplug the saw before accessing internal components. The owner's manual shows a detailed exploded parts drawing of that motor. Here is a link for the owner's manual in case you need it: Craftsman Table Saw 137.218100 Owner's Manual . You should be able to replace the brushes fairly easily using that information. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
June 22, 2012
See more answers