Model #128LD HUSQVARNA Line Trimmers/Weedwackers, Gas

  • Drive Shaft/handle/shield
    3 Results
  • Cylinder/fuel Tank/muffler
    3 Results
  • Service Reference
    3 Results
  • Service Reference
    3 Results
  • Service Reference
    3 Results
  • Service Reference
    3 Results
  • Drive Shaft/handle/shield
    3 Results
  • Cylinder/muffler/fuel Tank
    3 Results
  • Service Reference
    3 Results
  • Service Reference
    3 Results
Find part by diagram >

Question and Answers

Q:

Trimmer will only run on half-choke 128LD Husqvarna Trimmer

A:

Thanks for the inquiry and for being a valued member.

I am sorry to hear of the issue you're having with the trimmer. I know how frustrating that is.

This is a tell tale sign of a dirty carburetor that needs choke to provide fuel. You likely have a blocked jet, and when under load from throttle, starves out and dies. These smaller carbs are tough to clean. It's usually just better to go with a replacement. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
May 24, 2015
Q:

Husqvarna 128ld spring trigger location.

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina -
March 23, 2013
A:

Thank you for your question. I am sorry you are having a problem with the trimmer. I looked at the images you submitted. I think the way you have the spring installed in the third image is correct. I posted the image below of how I suspect it goes.     Please let me know if you need further assistance.  Thank you for using Manage my life.  Mark

Read More
Mark T -
Sears Technician
March 25, 2013
A:

What about on the 545062001 and 545067001 housing assembly? Where and how would the spring for the trigger assembly mount for that setup? I had the other combination but when i had to order the entire assembly that was what I was sent.

Read More
Bradley -
April 08, 2015
See more answers
Q:

Husqvarna Trimmer model #128LD Upper Shaft Replacement 128LD Husqvarna Trimmer

A:

Thanks for the inquiry and for using SearsPartsDirect.com.
The upper shaft kit will include the housing, the flex shaft, and the knob in the kit. The flex shaft will be pre-lubricated and the assembly is ready for install when you receive it. 
Hope this helps and let us know if we can be of any further assistance. Thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
May 27, 2014

Top Parts