Model #1236 KENMORE Bed electric

  • Platform Assembly
    3 Results
  • Frame Assembly
    3 Results
  • Electrical Assembly
    3 Results
  • Trim Panel Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Searching for a Deck Engagement cable Dynamark 12/38 Riding lawn mower. B3812120

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your lawn mower. Upon researching model B3812120:  the parts for this model are not supplied to us by the manufacture of the unit, I recommend contacting the manufacture of the product.

I trust this information will help you, we appreciate your business thank for choosing Sears.

 

Read More
CarlosZ -
Sears Technician
May 04, 2015
A:

I apologize, It is a 12/36 Dynamark not a 12/38

Read More
Ryan -
May 05, 2015
See more answers
Q:

dryer will not get hot DSXH47EG0WW Ge Electric dryer

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your dryer. Upon researching model DSXH47EG0WW; there are a couple parts it could be. There is he heating element. The heating element could be tested for continuity. There is the safety thermostat that can prevent the unit from heating up. Last is the thermal limiter. The thermal limiter could be tested for continuity. Click here for the diagram. The heating element is key number 1215. The safety thermostat is key number 1233 and the thermal limiter is number 1236.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
March 11, 2015
Q:

hotpointe nvl333eb1ww dryer not heating up... how to troubleshoot which part is needed?

A:

I know how important it is to have to have a good working dryer in the home so that you can dry your freshly washed clothes. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
April 16, 2013
A:

Thanks for the information about your dryer model nvl333eb1ww, I will be glad to assist you. There could be any number of things causing your dryer not to heat up. I will cover the basics that you can check yourself if you have the proper testing equipment. _Always disconnect power supply before servicing the appliance and when testing live voltage be sure to wear proper safety equipment (gloves and eye protection) also be aware of sharp metals on product_The very first thing to verify is the power supply to the dryer from your breakers, check the breakers both side must be on and operational(reset by turning off then back on)  next test power to the terminal block on dryer where the power cord connects, there should be 240 volts ac + _ 5%  using your volt/ohm meter. If this power reading is correct then proceed to test the heating circuit, Element, high limit thermostat, thermal cut off, cycling thermostat. I will attach images that will show electrical circuit and component locations. I hope this helps if you need additional assistance please reply with details and I will be happy to respond. If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.Ron H. Image below # 1215 heater housing, 1233 limit thermostat and 1236 thermal cut off, all test wires off should show continuity with volt/ohm meter.  

Read More
Ron H -
Sears Technician
April 18, 2013
See more answers