Model #11651513001 KENMORE Attachments (Vacuum)

  • Power-mate
    3 Results
Find part by diagram >

Question and Answers

Q:

How do I replace the power cord on my Kenmore power mate 116.51513001

A:

I see you need to replace the power cord on Kenmore power mate. While you are waiting on an expert to answer your question. You can visit SearsPartsDirect.com website to replace your power cord. I attached the link below. Hope this helps!

Read More
Dezeray S -
September 06, 2010
A:

Thank you for your question.

• To replace the power cord in the power mate locate the plastic cover on the back side of the swivel and pop it off by putting back pressure on the left side where the cover attaches to the swivel base.

• Remove the plug from the docking locations. Note how the wire is routed.

• Push the pedal release and move the swivel down.

• Next remove the top light lens by putting both thumbs on the front face of the lens and push up.

• Remove the light bulb. (Push in and twist left).

• Locate and remove the two Phillips screws next to light socket.

• Lift from the back and hinge forward the top cover and release from the front tabs.

• Lift up on the grey and white lever for the floor adjuster and pop out of its location.

• This will not expose the grey wire for the power. Unhook the wire from its retainer locations. (Note! the wire routing and its path. If you do not get the wire back in its same locations you may pinch and damage the wires when re-installing.)

• Un-twist the white wire connection for the light, motor, power cord.

• Locate the red button overload and pop it out of its holder and remove the black wire from the center contact.

• At this point you should be able to install the new wire harness.

• Connect all the whites wires with the wire nut and connect the black wire to the overload contact location and snap the overload back into place.

• Make sure you have all the wire tucked back in there proper locations.

• Re-install the height adjuster by tilting and tucking the two white tabs under the two black tabs on the base and push down to snap into place.

• Re-install the top cover by locating the front tabs and setting down and snapping into position. Making sure that the reset button aligns with the reset switch. Re-install the two Phillips screws and re-install the light bulb.

• Re-install the light lens.

• Re-locate the power wire in the channel and position it in the back of the swivel and snap the cover on.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
September 07, 2010
See more answers
Q:

Where can I find a wiring diagram for the 3 position PowerMate switch on vacuum cleaner model 116.51513001?

A:

The wiring diagram for your exact model of vacuum cleaner is not available. I suspect that the wiring for the switch on your model will be the same as the wiring shown in the diagram below.

Read More
Lyle W -
Sears Technician
November 19, 2009

Top Parts