Model #11634925401 KENMORE Vacuum, Upright

  • Nozzle
    3 Results
  • Dust Compartment And Motor
    3 Results
  • Hose And Attachments
    3 Results
  • Agitator Motor And Gear Assembly
    3 Results
  • Agitator And End Cap Assembly
    3 Results
  • Power Mate Jr.
    3 Results
Find part by diagram >

Question and Answers

Q:

how to replace the nozzle roller for Model #11634925401 Upright vac 11634925401 Kenmore Upright vac

A:

I added an image to this thread that shows how to access and replace that nozzle roller: http://www.managemylife.com/mmh/questions/264884-kenmore-upright-vacuum-cleaner-belt 
 
If you need more help, let us know. 

Read More
Lyle W -
Sears Technician
November 19, 2013
Q:

how do I change my kenmore upright vacuum cleaner belt?

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide the model # so your expert will be able to provide you the best possible answer. Just click on reply below and the provide the required data.

Read More
Priscilla V -
August 25, 2011
A:

Thank you for your question on how to replace the roller brush drive belt.

Without the model number I will only be able to give you some general information because of the different styles of Kenmore upright vacuum cleaners.

You will need to either remove the top cover on the nozzle assembly or flip it over to remove from 2 to 8 screws depending on the style to remove the top cover to get to the motor and drive belt for the roller brush.

If you will reply with the model number I can be more specific with my answer.

Sam A.

Read More
Sam A -
Sears Technician
August 26, 2011
A:

model u4461-9

Read More
Robert -
May 05, 2012
A:

Thank you for the model number of the Hoover vacuum cleaner. Turn the vacuum cleaner over and remove the bottom plate of the vacuum. This will expose the roller agitator brush and the drive belt. Lift out the agitator and remove the old belt and then install the new belt around the motor shaft and then around the where the belt rides on the agitator. Then stretch the belt and putting the opposite end of the agitator into the housing and then stretch the belt by pulling and then slide the agitator into its location in the housing. Spin the agitator by hand a couple of rotations to make it are aligned properly before you put the lower cover back on the vacuum. I have given you a generic video I found on line on how to change a belt similar to your model. I hope this will help you. Sam A.

Read More
Sam A -
Sears Technician
May 07, 2012
A:

Here is an image that shows how to replace the roller on an upright vacuum model 116.34925401.

Read More
Lyle W -
Sears Technician
November 19, 2013
See more answers
Q:

Wiring diagram

A:

Thank you for your question.  I will be happy to provide you with a wiring diagram.  The diagram is in the image below.  If the image does not enlarge properly then check you email for Plan B.  Thank you for using Manage My Life. 

Read More
Fred M -
Sears Technician
September 11, 2013

Top Parts