Model #11634612302 KENMORE Vacuum, Upright

  • Nozzle
    3 Results
  • Dust Compartment/motor
    3 Results
  • Hose And Attachment
    3 Results
Find part by diagram >

Question and Answers

Q:

Vacuum suction 11634612302 Kenmore Upright vac

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your vacuum. Upon researching model 11634612302; make sure all filters are clean or new. It could be the motor or Power board if it still has no suction and the motor is not on.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
March 03, 2015
A:

Thanks, will try that, if that does not work, can I myself replace the motor or power board, and if not, I have to take it to a repair shop? I appreciate all your feedback.

Read More
Eric -
March 04, 2015
See more answers
Q:

the right wheel on my Upright Kenmoor vacuum turns and stick sporatically.

A:

Vacuums seem to acquire many issues with the wheels and brush that slow down the cleaning. Often is is just string or other debris that wraps itself around the wheel. While you wait for the expert you can check the owner's manual for additional help if you like. I find mine helpful so I attached the online link to this model below in case you did not have one. I also added the link to Sears Parts Direct for the schematics and parts list if needed.

Read More
Barbara H. -
July 29, 2011
A:

The parts image shows the shaft as 2 parts, but it is just a single shaft.

I would turn the vacuum upside down and rotate the wheels by hand. If one wheel feels rough, remove it and inspect for something worn. More than likely the shaft will solve the problem.

Read More
Jimmy K -
Sears Technician
August 01, 2011
A:

One side of my long cam shaft has two small fins that stick out. Will the cam I order have those two "fins"....what is the purpose of those fins? Once again, the parts diagram does not show those two fins so I am really questioning whether to put $30 in parts (non returnable) if I'm not sure the cam is the right one. One of the techs on the phone indicated that my vac used to have the long shaft and then they changed it. Do you know anything about the part changing?

Read More
George -
August 04, 2011
A:

I understand your concern. If the part doesn't fit or solve the problem, you can't return it. The original part number for the cam shaft has not changed. The part should be the same as the original. I do not know what the fins on the shaft are there for. I am sure the replacement will work as it is intended. Do you see a worn or bad place on the original cam shaft? Whatever is causing the wheel to stick should be visible. If you feel sure the shaft is causing the wheel to stick replacing the shaft should cure the problem. If you are not comfortable repairing the vacuum, you can take it to a Sears repair center and get a technician to repair it for you. If you have any doubts about the repair, I suggest you take the vacuum in for repair.

Read More
Jimmy K -
Sears Technician
August 05, 2011
See more answers

Top Parts