Model #11631040900 KENMORE Vacuum, Upright

  • Dust Compartment
    3 Results
  • Fan Motor
    3 Results
  • Handle
    3 Results
  • Nozzle
    3 Results
  • Dust Cup
    3 Results
Find part by diagram >

Question and Answers

Q:

Gasket/Seal for top dust cup. 11631040900 Kenmore Vacuum

A:

Thanks for the inquiry and for being a valued member.

I am not specifically sure which seal you are in need of on the dust cap, as there are a few. To help you with the selection, I have linked the Sears Parts schematic for the dust cup on this model below.

Dust Cup Schematic for Model 116.31040900

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
March 02, 2015
Q:

vacuum 11631040900 Kenmore Vacuum

Q:

I have the Kenmore intuition bagless and beltless vacuum. The agitator stopped spinning and the supposed reset button is depressed already so I cannot press it

A:

I know you are eager to get the house chores done so you can enjoy the rest of the day.  I researched and found a link on a similar issue which may be helpful.  For additional information please provide the model number by clicking on reply to continue the thread.  Expert response time is within two business days.  Thanks for your patience.

Read More
Anna T -
May 22, 2013
A:

Thank you for your question and I understand your concern.

 As Anna suggested in the first response, we will need to know the model number of your Kenmore vacuum in order to provide any model specific information.  

I can give you help if you could provide me with the complete model number.  If you could supply me with that information I will be happy to assist you further. 

Read More
Joey S -
Sears Technician
May 24, 2013
A:

Model number 116.31040900

Read More
Jenie -
May 24, 2013
A:

Jenie; Thank you for adding the model number of your vacuum. Even though the reset button does not appear to have tripped, the reset button/switch could have failed. It will need to be disconnected and tested for continuity with an Ohm meter. If the reset switch is okay, the voltage supply to the brush motor will need to be measured. I recommend taking the vacuum in for service. I do not recommend making any voltage measurements unless you have experience and feel safe and confident in doing so, otherwise I recommend taking the vacuum in for repair. It could have a faulty brush motor or a faulty PCB control board.

Read More
Joey S -
Sears Technician
May 28, 2013
See more answers

Top Parts