Model #11329992 CRAFTSMAN Saw

  • Unit Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Antique (60 years old) Craftsman cleaning of gears abnd table surface 11329992 Craftsman Craftsman bench saw 10 in. tilting arbor

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Marc -
July 31, 2013
A:

This is a duplicate question. Please click the link below to follow the conversation.

Read More
Wade_B -
Sears Technician
August 01, 2013
A:

link?

Read More
Ian -
August 02, 2013
A:

http://www.managemylife.com/mmh/questions/354850-engage-tilt-screw-11329992-11329992-craftsman-craftsman-bench-10-tilting-arbor

Read More
Anonymous -
August 02, 2013
See more answers
Q:

Re-engage tilt screw on 11329992 11329992 Craftsman Craftsman bench saw 10 in. tilting arbor

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Marc -
July 31, 2013
A:

Most likely the handle is just seized in place. You may want to spray it down with some WD-40, or other penetrating oil, to see if you can get it free. Unless something is stripped out, I don't see any reason why you will not be able to get the threaded rod back in place to where it can tilt again.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
August 01, 2013
See more answers
Q:

Table saw mod #113-29992

A:

Removing the hand crank on the Craftsman can be tricky. While an expert is researching information for you, you may see what ideas others have in the link provided below. Thanks for your patience.

Read More
Anna T -
November 11, 2012
A:

Thank you for your question Tony. If the hand wheels spin freely after you have removed the Allen set screws then there may be a burr from the set screw that is not allowing the handle to slide off the shaft. I do not see in the parts picture another retainer screw that would be holding it on to the shaft. You may have to pull a little harder to get it to slide off the shaft. If you have enough room to get a vise grip onto the shaft you can hold the shaft while you pull and twist the handle to remove it.

Sam A.

Read More
Sam A -
Sears Technician
November 13, 2012
See more answers

Top Parts