Model #11329401 CRAFTSMAN Saw Radial

  • Cover Plate Assembly
    3 Results
  • Base Assembly
    3 Results
  • Saw Guard And Yoke Assembly
    3 Results
  • Motor Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

I'm trying to find a substitute part for a sears radial arm saw. The part is no longer available from sears. It is a thermal overload switch for the saw motor.

A:

I can understand your dismay over becoming aware that the thermal overload switch you're looking for is not longer available.  I have located a link that will discuss your situation in more detail. 
Click here to view the link.  Though this link discusses a different model number,
the mechanics are likely going to be very similar. Keep in mind that an expert will be
responding within the next two business days if not sooner and will likely offer you more information and
instruction. I hope this information will be helpful and have a nice day.

Read More
Henry -
June 28, 2013
A:

Thank you for contacting ManageMyLife.com regarding the thermal overload switch for your radial arm saw. I see Henry provided you with some good information. I'm happy to help you today.

I researched the part for you and unfortunately, I was not able to find a substituted part that will work for your model. I apologize for any inconvenience this may cause.

Thank you for using ManageMyLife.com.

Read More
Korinna S -
Sears Technician
June 28, 2013
See more answers
Q:

Craftsman saw radial #11329401 is important to me, I have used it for many, many years! I help want help to replace the bearing #30571 under the cover.

A:

When replacing a major part on an appliance I know how important it is to have detailed information to make your project much easier. While you are waiting for your expert answer, I did manage to find a link in where you can enter your appliance model number and a parts list diagram will pop up to guide you with your project. I hope my link is useful.

Read More
Joseph P. -
June 13, 2011
A:

Thank you for your question.

I can understand wanting to repair you Radial Arm saw.

It sounds like the bearing race is stuck on the armature shaft.

Have you tried carefully tapping on the end of the armature shaft while holding the end bell steady?

If it is moving at all off the armature shaft you may have to use some penetrating oil to work between the shaft and the bearing race.

If it only is coming off little way and then gets stuck I would suggest moving it back and using some sand paper and sand the shaft so you the bearing race will slide off the motor shaft.

I hope one of these suggestions works for you, and if I can help you further please reply.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
June 15, 2011
See more answers
Q:

owners manual for older craftsman radial arm saw

A:

Loosing a manual is easy, locating one is the hard part. Below I attached a link including your owners manual. I hope this helps!

Read More
Jackie S -
June 05, 2011
A:

Thank you for your question.

I can understand wanting to have the manual for your radial arm saw. It certainly would help with any set up and user information.

As you probably already know the owner's manual is no longer available either for download or purchase.

I found a 113.29402 on an old woodworking tool web-site. It looks like this reprint will be close enough to use for your model.

Old Wood working tool .

I hope this will work for you.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
June 06, 2011
See more answers

Top Parts