Model #11324511 CRAFTSMAN Drill Press

  • Unit
    3 Results
Find part by diagram >

Question and Answers

Q:

belt replacement on a drill press

A:

Vintage machinery can continue to provide years of reliable use. The expert will review and respond but if needed I attached two links from the web that you may be able to find a manual and information. I attached the links below. I hope these help.

Read More
Barbara H. -
March 01, 2012
A:

Thank you for your question on the drill press.

I do not have any service information but I did find a few pictures that may help you.

The original belt was a 1/2 X 44 inch belt and you would loosen the motor mount where it attaches to the drill body and then install the belt on the step pulleys and then slide the motor back until it is snug and tighten the lock.

I have found a sight with some pictures of this drill press model for you to look at.

Vintage power tools drill press .

I am sorry that I do not have a copy of the manual. This site may have a copy of the owner's manual.

Sam A.

Read More
Sam A -
Sears Technician
March 02, 2012
See more answers

Top Parts