Model #11324250 CRAFTSMAN Saw Table

  • Unit
    3 Results
  • Unit Breakdown
    3 Results
  • Fence Assembly
    3 Results
  • Motor Assembly
    3 Results
  • Switch Assembly
    3 Results
  • Miter Gauge Assembly
    3 Results
  • Guard Assembly
    3 Results
  • Table Extension
    3 Results
Find part by diagram >

Question and Answers

Q:

how do i get a part for old saw... trunnion front...part# 62099 11324250 Craftsman Craftsman 12 inch motorized table saw

A:

I have taken your part number and have gone to the SearsPartsDirect.com web site. I have created a link to that page and have provided it below. I will also forward your question to our expert team for further review. They will likely get back to you within a day or two. Until then, have a pleasant morning.

Read More
Henry -
September 30, 2012
A:

thanks Henry...Its a great saw...just needs that one part!

Read More
Lynn -
September 30, 2012
A:

I know that it can be very difficult to use your saw without all of the right parts. However, due to the age of this saw the parts are no longer available. Most manufactures stop producing them after 10 years, and I was unable to locate them anywhere. I would suggest that you consider purchasing a new saw. You can see what is now available at this link: Sears.com . I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
October 01, 2012
See more answers
Q:

how do i convert a 220v to 110v on my 12 inch craftsman table saw?

A:

My suggestion to you is to visit our Manage My Life website and click on the Manuals button, then you need to put in your model number and your Manual should appear. There should be a page that has some troubleshooting suggestions that might be helpful to you. I attached the link below. Hope this helps!!!

Read More
Raquel F -
July 13, 2010
A:

I did not find the owner's manual available online for this exact model of Craftsman table saw. I did find the manual for a similar model (113.24250) that uses the same motor. That owner's manual indicates that the saw can only be used with 240 volt (220 volt) power. Since the model 113.24250 uses the same exact motor assembly as the model that you have (113.24181), I suspect that you will not be able to wire the saw to use 110 volt power. This is likely why there are not any instructions on the motor plate for wiring the saw to 110 volt power. You can order the exact owner's manual for your model 113.24181 saw from the Sears PartsDirect website and verify this in the manual if you want to. The part number for the manual on saw model 113.24181 is 62597.

Read More
Lyle W -
Sears Technician
July 16, 2010
See more answers

Top Parts