Model #11324210 CRAFTSMAN Saw

  • Unit Breakdown
    3 Results
  • Miter Gauge Assembly
    3 Results
  • Guard Assembly
    3 Results
  • Rip Fence Assembly
    3 Results
  • Motor & Control Box Asm
    3 Results
Find part by diagram >

Question and Answers

Q:

Table saw model # 11324210 starts, smokes then blows fuse.

A:

I understand the concern with the table saw blowing out smoke. I have done some research on the Manage My Life website and have located a link similar to your issue. While you are waiting for a detailed reply from an expert I have provided the link below. Hope this helps!

Read More
Priscilla V -
July 22, 2012
A:

Thank you for your question on the table saw motor running slow and smoking.

I am sorry but it sounds like the motor for your table is burning out.

The worse part is that the motor on this old direct drive table saw is no longer available with any known replacement.

I looked at the other parts in the relay box and the relay is also no longer available.

The start capacitor is still available but it may be too late if the motor has already had smoke and odor coming out of it.

I am sorry that I cannot help you with this repair.

Sam A.

Read More
Sam A -
Sears Technician
July 23, 2012
See more answers
Q:

I have a sears 7 1/2" table saw model 11324210

A:

It seems almost impossible to remove and install a blade on the Craftsman table saw without a tool, but according to my research on managemylife.com, that's not true. The link below should help you while waiting for an expert advise.

Read More
Anna T -
May 30, 2012
A:

Hello John,

I'd like to help you with your question. On your table saw there may be a nut on the end of the motor, inboard from the saw blade and blade mounting hardware. This nut is pinned to the motor shaft and will not rotate independently of the shaft. The wrench size is usually 7/8 and it may need to be a thin profile or flat steel wrench.

If your saw does not have the inner nut, you can use the scrap wood method. Use a piece of scrap wood to hold the blade while using a wrench to unscrew the nut. I have included a video here that shows the entire process.

Please let me know if you would like any further assistance.

Jerry C

Read More
Jerry C -
Sears Technician
June 04, 2012
See more answers