Model #113235221 CRAFTSMAN Miter Saw

  • Figure 1
    3 Results
  • Motor Assembly
    3 Results
  • Pivot Assembly
    3 Results
  • Figure 4
    3 Results
Find part by diagram >

Question and Answers

Q:

miter saw does not turn on every time. 113235221 Craftsman 10 inch miter saw

A:

Thank you for being Sears’ valued member and for contacting SearsPartsDirect.com with your question about your Craftsman miter saw model 113235221. I am so sorry there is an issue with it not starting. I understand wanting to complete the repair yourself. In this case we advise against it. 

This product has a double insulated system. Any repair of this tool requires dielectric testing to ensure the operator’s safety. To avoid the possibility of alteration or damage to the double insulated system, service should only be performed by your nearest Sears repair center. The repair must be completed using the necessary diagnostic and testing equipment to assure continued compliance with applicable UL requirements. After the completion of the repair, the product must be checked using high voltage testing equipment to prevent a severe shock hazard which may occur if the part is not properly installed and tested.  
For these safety reasons we do not have a technical manual or electrical diagram that we can provide you. 

Here at SearsPartsDirect.com we love to help you with your do-it-yourself repair projects, but in this case, for your safety, the miter saw should only be repaired by a qualified technician with the proper testing equipment. Thank you for your understanding in this matter and thank you for choosing Sears, we appreciate your business. 
 

Read More
Rachel Morgan -
Sears Technician
June 22, 2015
Q:

Replacement part does not fit

A:

I did some research on the part and I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within two business days with detailed information. Thank you for using Manage My Life.  

Read More
Joseph P. -
March 07, 2013
A:

I posted the parts drawing for that saw in the image below. The handle is Key 23. The bolt that is Key 22 goes into the pivot assembly. You may be able to use the parts diagram in the image below to install that handle. If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
March 09, 2013
See more answers

Top Parts