Model #113235220 CRAFTSMAN Miter Saw

  • Figure 1
    3 Results
  • Arm And Motor Assembly
    3 Results
  • Pivot Assembly
    3 Results
  • Figure 4
    3 Results
Find part by diagram >

Question and Answers

Q:

Lower guard Part #: 823291 available anywhere else? 113235220 Craftsman 10

A:

Thanks for the inquiry and for being a valued member.

Unfortunately, due to the age of the miter saw, there is not a substitution being offered for the lower guard. We do not have a guard recommended to use. You can try running an internet search for the part number, but that would be the only viable option to find one. 

We apologize for the inconvenience and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
February 09, 2015
Q:

Excessive noise from saw 113235220 Craftsman 10" mitre saw

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Alina -
April 12, 2013
A:

I am sorry to hear about the problems that you are having with your Craftsman Mitre Saw Model 113.235220.

 

That noise that you are describing is probably caused by a bearing in the motor assembly. I don't think that the noise would be caused by any other types of failures. Here is a link for that part: Motor Assembly for Craftsman Mitre Saw Model 113.235220. 

 

That motor assembly is a fairly expensive part. I don't recommend that you spend that repair money on a replacement motor. It probably will be cheaper to replace the saw instead of repairing it.  

Read More
Lyle W -
Sears Technician
April 15, 2013
See more answers
Q:

Craftsman miter saw #113.235230 does turn on.

A:

I know that it can be very inconvenient for you not to have your miter saw working properly. While your waiting for a detailed reply from an expert. I have provided the link below. Good luck on the repair.

Read More
Yadira B -
September 05, 2012
A:

Thank you for your question on the miter saw motor not running.

I am sorry but the miter saw does not have a re-settable reset button. The motor only has an internal thermal but it should have reset when the motor cooled.

If you happened to overwork the saw and it was not the blade that was smoking then you should have had and odor that was different from the smoking wood from the blade.

Burning motor winding has a different odor and if that is the case it may have burnt out the field windings on the motor.

One other possibility is the start trigger switch has failed but it is unlikely from your description.

You could remove the brush caps and pull the brushes out to see if one of them is not touching the commutator and they are sliding in the brush holder freely.

In order to replace the motor you have to purchase the whole motor and gear box assembly. I will give you a link to this part.

Motor and gear box assembly for model 113.235220 .

It looks like you can purchase a new saw for less than repairing the old one.

10 inch compound miter saw .

Please let me know what you find out and we can continue troubleshooting with that information.

Sam A.

Read More
Sam A -
Sears Technician
September 06, 2012
See more answers

Top Parts