Model #113235140 CRAFTSMAN Miter Saw

  • Figure 1
    3 Results
  • Figure 2 Arm And Motor Assembly
    3 Results
  • Figure 3 Pivot Assembly
    3 Results
  • Figure 4
    3 Results
Find part by diagram >

Question and Answers




The saw tripping the breaker sounds inconvenient and can keep you from getting the job done. I am adding a link below to help you with your question while you wait for your expert response.

Read More
Joseph P. -
February 11, 2012

Try the saw on a different breaker to be sure you don't have a weak circuit breaker.

The saw has a run winding and a brake wiring. When the trigger is released, the switch energizes the brake winding to stop the blade quickly. If the switch has failed and is energizing the run and the brake winding at the same time, the saw will trip a circuit breaker.

Measure the resistance of the run and the brake winding to be sure there is not a short. If you read some resistance on the windings, they are good. If the winding is shorted or open the winding is bad.

Read More
Jimmy K -
Sears Technician
February 13, 2012
See more answers

Top Parts