Model #113213850 CRAFTSMAN Drill Press

  • Motor And Pulley Assembly With Guard
    3 Results
  • Key Switch Assembly
    3 Results
  • Base Assembly
    3 Results
  • Spindle Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Removing the chuck 113213850 Craftsman Craftsman 15 inch drill press

A:

Thank you for choosing Sears Parts Direct. I can certainly assist you in locating the instructions to remove the chuck for your drill press. I did look into the model number you have provided and I have found information to assist you

To remove the chuck turn the collar in the opposite direcrion until the chuck is ejected from the spindle.  You can find more information on page 10 of your Owner's Manual.

let me know if this helps.

 
You can also visit searpartsdirect.com for parts, diagrams, and repair information.
 
 
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services.

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
May 07, 2014
Q:

Replacement Stop Collar

A:

You're question is interesting and a good challenge for our investigative skills. Give us a day or two to investigate the matter further for you. We will be in touch and have a nice morning.

Read More
Henry -
September 30, 2012
A:

Thanks Henry!

Read More
William Sizemore -
September 30, 2012
A:

Thank you for your question on the stop collar for the drill press.

I am sorry but the manufacturer no longer supplies this part number 71321 and no matter what model drill press used this part it is no longer available as replacement part for any model drill press that used it.

I am sorry that I cannot help you with your request.

There is someone out in the web world on the wood working web sites that have one that they have parted out an old drill press and will sell it to you. You may want to check out some of the woodworking tool forums.

Sam A.

Read More
Sam A -
Sears Technician
October 02, 2012
A:

Sam, I understand that this specific collar is not available regardless of the model it was used on. Are there any other stop collars for later model drills that would fit/could be used on my drill and would still be available for purchase? Thanks, Bill

Read More
William Sizemore -
October 05, 2012
A:

Thank you for the update. I have looked at some other models and I was not able to verify that any of the Rigid models would fit. You might want to check with you local Home Depot in the tool department to see if there model will fit. I am sorry that I am not able to help you better. Sam A.

Read More
Sam A -
Sears Technician
October 05, 2012
See more answers
Q:

How do I replace the rack on my drill press model 113.213850

A:

I would like to know how to replace the rack on my Sears drill press

Read More
arlint -
August 23, 2010
A:

The easiest way I have found to replace the rack on a drill press is to remove the drill head from the column. Then remove the collar, loosen the table support and slide the assembly off the top of the column. Place the new rack with the table support and slide it back down the column. I hope this is helpful.

Thank you for using Manage my life.

Here is a link to order any parts you need. Sears Parts Direct .

Read More
Mark T -
Sears Technician
August 24, 2010
See more answers

Top Parts