Model #113177001 CRAFTSMAN Wet/Dry Vacuum

  • Unit
    3 Results
  • Accessories
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a wet dry vac #113177001, and I have a new hose to vacuum adapter, #73324. I can't get the adapter into the hose. Please assist.

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner. Have a great day!

Read More
Alina F. -
June 28, 2012
A:

Thank you for your question on the new swivel adapter not fitting the old hose.

If this is the same as the original hose adapter swivel it should thread right onto the hose.

I would not think it would be a problem. You say the adapter is about the same outside diameter as the hose.

The adapter should be slightly smaller so the hose would fit over the adapter. From the ones I have seen the hose should thread onto the adapter.

Maybe if you could take a couple of pictures and post them I would be able to give you some better instructions.

Please let me know if you can do that.

Sam A.

Read More
Sam A -
Sears Technician
June 30, 2012
A:

my camera is down right now. but the part has a lip all around the outside of the part to be installed into the hose so as to when installed it will not pull out of the hose. turning seems like it should work but I can't get the part started into the hose

Read More
Dana -
October 16, 2012
A:

Thank you for the update on the hose adapter. Is it possible that you are trying to put it on the wrong end of the hose? Is there still a piece of the old adapter on the inside of the hose? I doing research on this adapter it look like it should fit onto the hose with little effort. When you get your camera up again it may be helpful. Sam A.

Read More
Sam A -
Sears Technician
October 16, 2012
See more answers
Q:

Is there anyone at your location that can actually look at a part for me from a wet dry vac?

A:

I know how important it is to have detailed instructions when replacing a major part on your appliance. While you are waiting for an expert answer, I did manage to find a link that will provide you with some good tips to help you with your project. I hope my link is useful.

Read More
Joseph P. -
March 22, 2011
A:

Thank you for your question.

I can understand you dilemma with the hole in the fan wheel so large.

The fan is held onto the motor shaft with nut. So the shaft on the motor is threaded.

It sounds like either the fan can loose and was spinning on the motor shaft or the motor shaft were the fan is attached is broken or sheared off.

If the end of the motor shaft does not have any threads you will have to replace the motor.

If the threads are still there you will have to get a new fan wheel and the nut/washer and spacer which go on the top side of the fan.

The parts as listed in the parts list shows the nut � x 20 is part number: 73352, the washer is: 15534-1 the fan blower wheel is: 818413-2 and the spacer is: 818961.

If you need the motor the part number is: 829693. And you can purchase them from: Sears Parts Direct .

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
March 23, 2011
See more answers

Top Parts