Model #11111 KENMORE Wall Oven, Gas

  • Control Panel
    3 Results
  • Basic Body
    3 Results
  • Ignitor
    3 Results
  • Door
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Troubleshooting Kenmore Elite Oasis Steam Electric Dryer Model 110.C68062801 changing pre-set dryness level settings.

A:

ManageMyLife does not have access to parts for Canadian appliances nor can we troubleshoot Canadian products. Your expert can answer this in more detail. That is why you do not have the ability to register by Canadian zip codes.

Read More
James -
January 01, 2013
A:

Hi,

Thank you for asking this question and allow me to answer it this way.

When you say off, you mean the power is on and the dryer is not on a cycle. This means the display is lit up. But the dryer is not running. So turn the power on and follow the directions that you listed and you should be Ok.
Sears is formed like this Sears USA: Sears Canada so on and so forth. ManageMyLife is Sears USA. All the things listed in the websites are for USA products. An example is the model 110.C68062801 the C stands for Canada. And you model will not run in our systems. For me to look up a part for your dryer I must use a system called Canadian LIS then take that part number and put it in the USA LIS system and look the part up from there. The way to get some information downloaded is to drop the C off the model number and it becomes 110.68062801 and there in the USA manual the instructions are the same.

I hope this answer is useful and that it helps you correct the problem with your appliance.
Thank you for using ManageMyLife.

Read More
Bill__W -
Sears Technician
January 03, 2013
See more answers
Q:

Do I need to change oil in a new snowblower that was used less than one hour or can I wait until next year when I reach the 5 hour mark?

A:

Keeping out tools in order and ready to go is just being smart. ManageMyLife has some great videos and articles that are full of useful information. I did some research at the website and found these excellent article that may help until your expert can respond. The link is attached below. I hope this will shed some light on the subject for you.

Read More
James -
April 13, 2012
A:

Gary - Should it be mine I would follow all the other 'summer lay up' instructions in the appropriate manual but leave the oil change until just before the first use next winter.

Read More
biguggy -
April 13, 2012
A:

Thank you for your question and I understand your concern.

With less than one hour of run time on the engine it is not necessary to change oil until it reaches 5 hours of run time. I would wait until it reaches the 5 hour mark to change the oil.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post

Read More
Joey S -
Sears Technician
April 13, 2012
See more answers
Q:

DP100P not draining after wash cycle?

A:

Any appliance that leaves water behind would be distressing. If you can provide a bit more detail such as the make and complete model number it will help the expert provide a better answer. Just click reply and add the additional detail. The model number often begins with three numbers followed by a period, then more numbers. For example 110. 11111. If you do decide to schedule a qualified technician to help with the diagnosis and repair, I atttached the link to Sears Home Services below.

Read More
Barbara H. -
February 24, 2012
A:

I know that this can be a very frustrating problem for you. However, in order for us to provide you with an answer, we will need some more detail. If you could please reply with a type, make and model of the appliance. We can then research the problem and find you a solution. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
February 24, 2012
See more answers