Model #11097561603 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • 8576353 Burner Assembly
    3 Results
  • Door Parts, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

HE2 Gas Dryer Model#110.9756.1603 Push start beeps everything lights but status lights, dryer won't start? 110.9756.1603

A:

You could have a problem with the door switch. I recommend that you use the diagnostic test cycle to check that door switch component. Here is a link for a previous answer that provides instructions for the diagnostic test and other troubleshooting for this type of failure:  http://www.managemylife.com/mmh/questions/291006-kenmore-he2-front-load-dryer-start-button

 

If the door switch is bad, then it will need to be replaced. Be sure that you unplug the dryer before accessing internal components.

 

If you need more help, reply with additional details and we will assist you further. 

Read More
Lyle W -
Sears Technician
November 19, 2013
A:

Note: Use the bottom image in that thread that I posted above. Some of the image in that previous thread do not display properly.

Read More
Lyle W -
Sears Technician
November 19, 2013
See more answers
Q:

Installing door latch kit 110.9756.1603

A:

I am sorry that you are having some difficulties with your dryer door and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your research while you wait for your expert response.

Read More
Joseph P. -
February 25, 2013
A:

Thanks

Read More
John -
February 25, 2013
A:

Hi,

Thanks for contacting ManageMyLife. I understand how frustrating it is having trouble with your appliance not working.

Ok the door should be removed from the cabinet by removing the phillips headed screws holding the door to the cabinet. 

Lay the door face down on a cushioned table and remove the screws from the inside of the door and separate the door halves.  There will be two of the screws holding the latch to the inside half of the door.   

Please feel free to let me know if you need further assistance. We are always here to help.

Thank you for using ManageMyLife.com.

Bill

Read More
Bill__W -
Sears Technician
February 26, 2013
See more answers
Q:

model 11097561603 HE2 Kenmore dryer, how to replace belt diagrams?

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina -
November 30, 2012
A:

Thank you for submitting your question. The installation of parts can be tricky sometimes and I will be happy to assist you. The images below should assist you with the routing of your belt. For more visual assistance, here's a great video on how to install this belt. I hope this helps. Please reply back to this thread if you require further assistance. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
December 01, 2012
See more answers

Top Parts