Model #11096582110 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Trying to figure out cubic feet of washer and dryer

A:

Trying to figure out the cubic feet on your appliance is very great to know. While you are waiting on an expert to answer your question, you can visit Sears Parts Direct website to speak with a Sears associate to find out the cubic size. I have attached the link below. Have a nice day!

Read More
Dezeray -
August 13, 2012
A:

Thanks for contacting ManageMyLife.com. I understand your concern with finding out the cubic foot of the washer and dryer. We are here to help. The washer is a 3.0 cubic ft and the dryer is 6.3 cubit ft. I hope this helps.

To visit sears.com sears.com .

Please feel free to let me know if you need further assistance. We are always here to help.

Thank you for using ManageMyLife.com.

Read More
John H -
Sears Technician
August 14, 2012
See more answers
Q:

wire instruction

A:

I understand the importance when it comes to the wiring of a dryer. I have done some research on the Manage My Life website and have located a link quite similar to your issue. While you are waiting for a detailed reply from an expert I have provided the link below. Hope this helps!

Read More
Priscilla V -
June 05, 2012
A:

The instructions for the 3 wire and 4 wire terminal wire hook up are in the images below. Remember to unplug the dryer first. If you are referring to another terminal then let me know and will try to help further.

Read More
Fred M -
Sears Technician
June 09, 2012
See more answers
Q:

Dryer not heating/timer not advancing

A:

When it comes to an appliance not working properly it can be really frustrating. While you are waiting on an expert to answer your question, I suggest you set service with a Sears technician. I have attached the link below. Have an nice day!

Read More
Dezeray -
May 29, 2012
A:

If the dryer heats and advances in the Timed Dry cycle then I suspect the problem with the timer not advancing in the automatic cycle is a bad resistor. When the dryer is heating the resistor prevents any voltage from reaching the timer. when the element shuts off then the resistor allows voltage to the timer. The resistor is located near the timer. The element might be the problem is the dryer doesn't heat at all. The 279872 resistor is available from the following link: Resistor for Kenmore Dryer . If the dryer heats then this is the most likely cause of the timer not advancing in the automatic cycle.

Read More
Fred M -
Sears Technician
May 29, 2012
A:

To emphasize from first post...I have no heat at all. Timer advances only in timed heat mode.

Read More
Patrick -
May 29, 2012
A:

Then the resistor is the place to start. If you have a meter then it can be checked of an open circuit. The resistor can be obtained from the following link: t have a meter you might give it a try. The resistor is the most likely cause of this problem. Remember to unplug the unit first.

Read More
Fred M -
Sears Technician
May 30, 2012
See more answers

Top Parts