Model #11096572800 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dryer runs but no heat

A:

I am sorry that you are having some difficulties with your dryer and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I am also adding a second link in where you can set service to have your dryer repaired by a certified technician. I hope this helps with your dryer troubles while you wait for your expert response.

Read More
Joseph P. -
November 10, 2012
A:

I know that it can be very confusing to have your dryer stop heating, especially when all of the parts are testing okay. The heating element must have 220-240 volts supplied to it or it will not heat which means it must have L1 and L2 voltages. The motor centrifugal switch also must close contact 2M to 1M in order to provide the heating element with Line two (L2) voltage. The image below will provide a wiring diagram for this model. You will need to test the switch. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
November 11, 2012
A:

As I stated in my original question, i am getting 240v supplied to the unit.. I also removed the Motor and tested the centrifugal switch. the resistance on both may be slightly out of range. I plan on getting a motor and seeing if that is indeed the problem. thx for your response. Annej

Read More
reggie -
November 11, 2012
See more answers

Top Parts