Model #11096551200 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Why is the push to start button not working on my dryer?

A:

It is difficult to accurately predict the cause of your failure without the model number of your dryer. If the dryer has an electronic control board and relays for the motor and heater, you could have a failed relay or a failed control board causing your problem. A failed centrifugal switch in the motor could also cause this problem on some models of dryers.

For more help with this problem, resubmit your question with the full model number of your dryer.

Read More
Lyle W -
Sears Technician
October 03, 2008
A:

11096551200, i have a kenmore that just did the same thing today

Read More
amanda -
October 18, 2011
A:

my model number is 110.60954990 sn ml060995 tyoe ddot-eloite 2406028eh54

Read More
BRIAN -
January 12, 2013
See more answers
Q:

Heating element for Kenmore dryer.

A:

I know how important it is to have all of your appliances working properly. While you are waiting for your expert answer, I have found a link that will provide some information on the issue. It does include images of the instructions for replacing the heating element. I hope this link will help you.

Read More
Anne -
October 03, 2011
A:

The element is located behind the rear panel of the dryer.

Remember to unplug the dryer first.

The image below will help you complete this project.

Any parts you need can be obtained from the following link: Sears PartsDirect .

I hope this helps and thank you for the question. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
October 04, 2011
See more answers
Q:

How can I fix my Kenmore dryer that has stopped drying clothes?

A:

You may be able to fix this problem yourself. Here are some issues to check:

  • Check the house breakers (or fuses) for the dryer outlet first. The dryer will run if only one of the 120 volt legs of 240 volt power is supplied to the dryer. If the second leg of 120 volt power is missing, then the dryer will not heat.
  • If the breakers (fuses) are okay, then I recommend checking to the voltage at the dryer outlet using the diagram in the image below. NOTE: You should only check this live outlet voltage if you are completely confident in your technical ability to safely measure it with a volt/ohm meter.
  • If the outlet voltage is okay, then I recommend unplugging the dryer and checking the heating element and other components in the heating circuit as described in this link of a previous answer: Why will my Kenmore Series 70 run but not get hot? When you unplug the dryer and pull the back panel off, you will see components similar to the ones in the second image below. Your dryer will have a thermostat instead of the thermistor shown below. The location of the thermostat will be the same as the thermistor. Your heater will be at the bottom of the heater box on the right side.

NOTE: Be careful when accessing internal parts in the dryer. Internal metal edges can be sharp. Make sure that the dryer is unplugged when accessing these parts.

If you are able to access and check these components, you may able to diagnose and repair the dryer yourself using the tips provided above. If you need parts, you can order them from the Sears PartsDirect website. Key your full model number (110.96551200) into the search field to access the parts list diagram for your dryer.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
February 24, 2009

Top Parts