Model #11096283100 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Dry Rack
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I replace the Cycling Thermostat in my dryer 110.96283100

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Marc -
July 17, 2013
A:

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when needing to change your thermostat on your Dryer. I did do research and I have found a couple resources that will help you change your thermostat out on your dryer. Click here for the instructions. Let me know if this helps.

 

Thank you for your question. Have a great day.

Read More
Natasha12 -
Sears Technician
July 18, 2013
A:

There is no access panel on the bottom of the machine as described in the reference.

Read More
Howard -
July 18, 2013
A:

Okay it is the bottom toe panel that needs to be removed.

Read More
Natasha12 -
Sears Technician
July 18, 2013
See more answers
Q:

How do I replace the heating element on my Kenmore dryer model 110.96283100?

A:

I have included a set of illustrated instructions (See below). These should step you through the process of replacing the heating element. Make sure to unplug the dryer before starting the repair.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Mark T Personal Solutions Manager -
Sears Technician
February 09, 2010
Q:

Why does my Kenmore electric dryer model number 110.96283100 run but does not heat?

A:

Why does my Kenmore electric dryer model number 110.96283100 run but does not heat?

The heating element requires 220-240 volts in order to heat. The dryer will run on 110-120 volts if one of the two circuit breakers dedicated for the dryer trips. I recommend locating the two house circuit breakers dedicated for the dryer and reset both breakers by flipping them both OFF and back ON 2-3 times and then recheck the dryer for heat. If it continues to not heat the failure could be one of many components connected in series with the heating element.

  • Thermal cutoff
  • Operating thermostat
  • Hi Limit thermostat
  • Heater
The heating element and the other components can be accessed by removing the lower rear panel. Disconnect the power cord from the power source (outlet). You will need an Ohm meter to check the continuity of each component until you find one no showing any continuity. Make sure to test each component individually and to disconnect both wires from the component being tested for continuity.

If you do not feel comfortable performing this task I will suggest scheduling service at 1-800-469-4663.

Read More
Luis L -
Sears Technician
January 02, 2010

Top Parts