Model #11094570100 KENMORE Residential Washers

  • Rear And Side Panel
    3 Results
  • Console And Front Panel
    3 Results
  • Washer Top And Lid
    3 Results
  • Wiring Harness
    3 Results
  • Tub And Basket
    3 Results
  • Miscellaneous
    3 Results
  • Optional Permanent Install Kit
    3 Results
  • Machine Base
    3 Results
  • Motor And Pump
    3 Results
  • Gearcase
    3 Results
  • Brake And Drive Tube
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Strike does not depress into the hole enough for the spin cycle to finish 11094570100 Kenmore Compact washer

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your washer and I do understand your frustration. Glad to help out. I'm looking at your model number 11094570100 and the problem you are describing can be an issue with the lid switch  or the strike on the lid. The lid has a strike that pushes in the opening that you are using to press the switch manually. It is possible that the strike is damaged and not reaching the switch actuator. Here is a video that will help with the repair. I have included a link to our PartsDirect page where you can purchase the part you need to complete your repair. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 09, 2014
Q:

Why does my Kenmore washer model 110.94570100 shake and vibrate?

A:

Several different problems could cause this washer to vibrate and shake in the spin mode. Make sure that you properly removed all 3 shipping straps according to the installation instructions. Although the installation manual for your exact model is not available online, I provided the installation manual for an almost identical Whirlpool model below. I also provided an owner's manual from this similar model. Make sure that you followed all of the installation instructions properly.

If the tub is leaning, you could have a problem with one of the suspension springs (Key 5 in the image below).

I recommend checking the counterweight spring and bracket. The spring is Key 4 and the bracket is Key 15.

These tips should help you resolve your vibration problem in the washer. If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician

Top Parts