Model #11092599400 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket, Tub
    3 Results
  • Miscellaneous
    3 Results
  • Gearcase, Motor & Pump
    3 Results
  • Bleach, Detergent & Rinse Disp.
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

how come my washer over flows while filling

A:

Deciding if a repair is a good do it yourself project does take enough information to make a decision. The expert will review your model and provide advice and instructions to help. As to the parts and parts cost you can check the first link below for your washer model at Sears Parts Direct. The answer to having a Sears technician make the repair is also easy. The second link below to Sears Home Services will help you schedule. Hope this information and the links helps with your decision and repair.

Read More
Barbara H. -
August 19, 2011
A:

Thank you for your question and I understand your concern.

I highly recommend calling a service technician to diagnose and repair your washer. It could have a hole in the water level pressure switch hose or it could have a water level/transducer failure. The service fee is $130.00 which includes the labor to repair but not the parts. You would be responsible for the parts and service fee. The microcomputer board is part #3407108R at the approximate cost of $110.00 and the water level transducer is approximately $90.00

This is what a service technician would need to do in order to test the transducer/water level pressure switch:

With machine ON and tub empty, check for 2-3 VDC between Pins 7 (yellow with black stripe) and 8 (white with grey stripe) on connector P1 of the Microcomputer Board. If voltage is correct, replace the Microcomputer Board. IF voltage is incorrect, check harness connections. If harness connections are OK, replace the water level transducer. NOTE: I do NOT recommend checking and verifying voltage unless you have experience and you feel safe and confident in doing so; otherwise I recommend calling a service technician to diagnose and repair your washer.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
August 22, 2011
See more answers

Top Parts