Model #11092593420 KENMORE Residential Washers

  • Control Panel
    3 Results
  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Dispenser
    3 Results
  • Water System
    3 Results
  • Wiring Harness
    3 Results
  • Gearcase
    3 Results
  • Brake And Drive Tube
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


Kenmore top load washer #11092593420, the tub will not spin & doesn't completely drain the water. I can move the tub with my hand. This is a great, in the


Diagnosing Washers can be difficult. While you wait for the expert to review your model, you can check a similar question from a previous expert post if you like. I attached a few links below. If you do decide you prefer to have a technician diagnose and make repairs, an option is to visit Sears Home Services and use the handy scheduler.

Read More
Priscilla V -
February 14, 2011

Thank you for your question.

I can understand wanting to repair the washer even when it is 16 years old.

If may however not be cost effective to fix this old washer since you have had so many years of use.

This washer has a neutral drain process where it will drain most of the water out of the tub before the motor will stop and reset the drive in the transmission and then start back up again for spin.

If it is trying to spin but only spinning slowly, it could be a worn out clutch.

If it is not even attempting to spin it could be the lid switch not closing. If the washer has water in it turn the timer to the spin position and lift the lid and put a pen tip into the lid switch to see if the washer will at least attempt to spin.

If it begins to spin then the lid switch could be broken and the strike is not pushing the lid switch far enough to activate the spin cycle.

If you can smell any rubber like odor it could be the motor drive coupling that has broken and you would have to remove the cabinet and remove the pump and motor to get to the coupling.

Tell be what you have discovered and if you need further instructions please use the thread link to give me an update as to what you have found and I will be happy to help you further.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 16, 2011
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show