Model #11092585800 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Control Panel
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Gearcase
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Hi, my Kenmore washer model 11092585800 is overflowing.

A:

I see you entered a previous question for this issue. I can understand how important it is to have a leaking washer fixed sooner rather than later. The experts do review and respond within two business days if not sooner.

Read More
Barbara H. -
May 12, 2011
A:

Thank you for your question and I understand your concern.

I must assume the water will shut off when the timer is pushed in to turn the washer off.

The tub must be empty of water before reconnecting the clear pressure switch air hose to the water level pressure switch or it will overflow if you start the washer with water already in the tub.

If you had the tub empty of water before installing the new water level pressure switch and water continues to fill over the top of the tub then the clear pressure switch hose may have a pin hole or a blockage preventing the slight amount of air pressure that builds up inside the air dome from reaching the water level pressure switch. Remove the washer cabinet and inspect the pressure switch hose. NOTE: Disconnect the power cord from the power source before placing the console in the service position.

Read More
Joey S -
Sears Technician
May 14, 2011
See more answers
Q:

I have a Kenmore washer model: 11092585800

A:

I understand how important it is to have your appliances working. While your are waiting for your expert answer, I have found two links that will be able to provide some information on this problem and how to fix it. I hope that these will help you.

Read More
aashe -
May 12, 2011
A:

Thank you for your question and I understand your concern.

I must assume the water will shut off when the timer is pushed in to turn the washer off.

The tub must be empty of water before reconnecting the clear pressure switch air hose to the water level pressure switch or it will overflow if you start the washer with water already in the tub.

If you had the tub empty of water before installing the new water level pressure switch and water continues to fill over the top of the tub then the clear pressure switch hose may have a pin hole or a blockage preventing the slight amount of air pressure that builds up inside the air dome from reaching the water level pressure switch. Remove the washer cabinet and inspect the pressure switch hose. NOTE: Disconnect the power cord from the power source before placing the console in the service position.

Read More
Joey S -
Sears Technician
May 14, 2011
See more answers

Top Parts