Model #11087983810 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Dry Rack
    3 Results
  • Bulkhead
    3 Results
  • 3387617 Burner Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I fit a replacement seal in my dryer? 11087983810 Kenmore Gas dryer

A:

Thank you for choosing Sears, I will be more than happy to assist you with your Kenmore Dryer.

From the information you have provided above, I have located a video on how to get the part replaced for your dryer. Click here for the video.

I hope you found this information helpful. Thank you for choosing Sears Parts Direct. We appreciate your business. Have a great day 

Read More
Samantha A -
Sears Technician
December 05, 2014
Q:

need video or manual on how to change drive belt on kenmore dryer model 11087983810

A:

 Thank you for your question and I understand your concern.

The control panel must be placed in the service position by removing the screws in the left and right front corners of the control panel. The screws along the rear of the top panel on the top will need to be removed and then slide the top forwards and off. Then the lower access panel below the door must be taken off. Then remove the screws at the top of each side panel securing the top of the front panel and look to see if there is screw on each lower side of the front panel. If it does not have the two lower screws, lift the front panel up off the two hanger brackets. Disconnect the door switch wire connections and remove the front panel. I added several images below to reference the procedures.

NOTE: Disconnect the power cord from the power source before servicing. 

 I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.


Read More
Joey S -
Sears Technician
October 18, 2013
Q:

igniter works for about 8 min until dryer is warm. then it glows and glows and wont reignite until dryer is cool again. 11087983810 Kenmore Gas dryer

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner. Have a great day!

Read More
Alina -
December 28, 2012
A:

I see you have checked all the usual suspect parts for this issue. These symptoms point to failed gas valve coils. There is an observation port on the lower left side of your front panel under the door. Pull the plug on that port and observe the burner assembly when the dryer is running and not heating. It is likely that you will see the igniter glowing and then cycling off. It will likely repeat this process continuously. If the igniter is functioning in this manner, then your likely failure is the gas valve coils. Weak coils will normally be strong enough to open the gas valves when from a cold start. This is likely why the dryer initially heats. After the coils heat up, they are likely too weak to open the gas valves to light the burner. The images below can help guide you through these checks. If parts are needed, you can order here; Sears Parts Direct .

If further information is needed, please reply. Thank you for using manage My Life.

Read More
Barbara H. -
Sears Technician
December 28, 2012
See more answers

Top Parts