Model #11087694500 KENMORE Residential Dryer

  • Limited Edition Console Panel Parts
    3 Results
  • Limited Edition Cabinet Parts
    3 Results
  • Limited Edition Bulkhead Parts
    3 Results
  • Limited Edition Dryer Top Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

testing sensor on dryer Part number 696371 11087694500

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

I did look into the model number you have provided, and I have found that the tubing should not be closed. The tubing should be open because there needs to air going through both sides of the pressure switch(sensor).

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
October 24, 2014
Q:

Kenmore Solid State Electronic Dryer does not dry clothes properly anymore.

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Jackie S -
November 06, 2011
A:

Thanks for contacting ManageMyLife.com. I am sorry you are having a problem with your dryer. When a gas dryer is running but the ignitor isn't glowing and it's not heating the most likely reason why is an open thermal fuse.

The thermal fuse is located behind the rear access panel on the blower housing. See the image below for help with this.

Remember to unplug the dryer first.

A gas dryer will run with an bad thermal fuse but it won't heat.

The thermal fuse can be checked two ways. The first is with a volt/ohm meter if you have access to one and are comfortable using it. Check for continuity/resistance across the fuse. If it is open then replace it.

If you don't have a meter or know how to use one there is another way the thermal fuse can be checked. With the dryer unplugged you can remove the two wires off the thermal fuse and join (jump) them together with a small insulated wire with two bare ends. Make a good connection and put a little electrical tape around the connections.

Don't let it touch anything metal and then with caution plug the dryer back in and see if it will heat. If it does then replace the 3392519 thermal fuse. Don't continue to use the dryer with the fuse bypassed.

If the ignitor is not glowing then the operating thermostat, hi-limit thermostat or radiant senor can also be the problem but the thermal fuse is the most likely.

To order parts or view full diagrams please visit SearsPartsDirect.com with the model number.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. You may visit SearsHomeServices.com and click on the red Start now button.

Please feel free to let me know if you need further assistance.

Thank you for using ManageMyLife.com.

Read More
Jonathan B -
Sears Technician
November 08, 2011
See more answers

Top Parts