Model #11087673100 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I need to know the BTU rating for my Kenmore gas dryer model number 110.87673100 so teh gas CO engineers can engineers correct gas piping size.

A:

Thank you for your question and I understand your concern.

The gas burner is rated at 22,000 BTU's.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
May 25, 2012
A:

BTU rating a very important for a plumber to get the correct piping for the Kenmore dryer. An expert will be with you within 24-48 hours with the information you are requesting for your specific model. Thanks for your patience.

Read More
Anna T -
May 25, 2012
See more answers
Q:

Why does my Kenmore dryer model 110.87673100 run but does not produce heat?

A:

Make sure that the gas shut-off valve is fully open and that the dryer has an adequate supply of gas provided to it.

To diagnose the heating problem, you will need to understand the theory of operation of the gas valve assembly as shown in the image below. If you remove the bottom panel of the dryer and start the dryer with a medium load of wet laundry in the drum on a heated cycle, you can observe the gas valve assembly to determine whether the igniter is glowing. If it is then most of the components in the electrical circuit are okay. If the radiant sensor opens to shut off the igniter and current flows through the main coil (Valve 2) but the burner does not ignite then it is likely that you have bad gas valve coils. In this situation, replacing the gas valve coils on the burner would likely fix your dryer heating problem.

You can order the gas valve coils from the Sears PartsDirect website. There is a lower priced kit that contains both coils. The part number for the kit is 279834. Be sure that you unplug the dryer before accessing and changing this part.

If the igniter is not glowing then you could have one of these failures:

  • Bad igniter
  • Open radiant sensor
  • Open high limit thermostat
  • Bad operating thermostat
  • Failed timer contact
  • Bad motor centrifugal switch contact
  • Wiring failure in the heating circuit
If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
February 06, 2010
Q:

What is wrong with my Kenmore model 110.87673100 gas dryer when it runs and lights but the flame is to low to dry the clothes?

A:

The weak flame can indicate a problem with the coils but first I'd still recommend you remove the vent hose from the back of the dryer. I know the vent is new but I'd still remove the vent hose from the back of the dryer and see if the flame sizes increases.

As long as the gas supply has not be changed from propane to natural gas the problem is most likely to be the valve, coils or pressure regulator on the gas supply.

If the flame stays small after removing the vent hose from the back of the dryer then I'd recommend changing the gas coils. One odd thing about the coils is that you can order a kit with both coils 279834 that is cheaper than one coil individually.

The coils are economical (approximately $22 dollars) to change and if the problem doesn't improve then the gas valve will most likely have to be changed.

Read More
Fred M -
Sears Technician
August 06, 2009

Top Parts