Model #11087273100 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • Burner Assembly
    3 Results
  • Burner Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

gas dryer is producing no heat but runs - ideas? 11087273100 Kenmore Gas dryer

A:

Diagnosing dryers can be difficult. I located a similar issue that may help while you wait for the expert. If parts are needed, the Sears Parts Direct link can help. Both links are below.

Read More
Barbara -
November 17, 2012
A:

When a gas dryer runs but doesn't heat the first thing to check is the thermal fuse located behind the rear panel. The image below will be helpful. Remember to unplug the dryer first. The thermal fuse can be checked for continuity with a meter is one is available. The fuse can be bypassed if a small piece of insulated wire is available. I hope this helps. You can reply with additional questions or details if further assistance is needed.

Read More
Fred M -
Sears Technician
November 18, 2012
See more answers
Q:

What is the difference between different thermostats on a Kenmore Gas Dryer?

A:

I know this type of information can be very helpful for you to have.�While you are waiting for your expert answer, I did some research on the unit.�I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information.�Thank you for using Manage My Life.

Read More
Joseph P. -
November 14, 2011
A:

That thermostat on the inlet drum from the gas flame (part 279048) is a high limit safety thermostat that is rated to "open" at 205 degrees. The other 2 thermostats (part 694674) are operating thermostats. Those replacement thermostats are adjustable. The original 2 thermostats on that outlet were rated at 140 and 150 degrees. The adjustable replacement thermostats need to be adjusted to those temperatures using the information that was included with that part. If the high limit thermostat is switched with one of the operating thermostats, this could cause heating problems in the dryer. If the two operating thermostats on the blower housing are switched between themselves in that same location, then that should not have much of an affect as long as they are adjusted to the proper temperature. I hope that this information helps. If you need more assistance, reply with additional details.

NOTE: Be sure that you unplug the dryer before accessing internal components.

Read More
Lyle W -
Sears Technician
November 16, 2011
See more answers

Top Parts