Model #11086273800 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

SEARS DRYER MODEL # 11086273800 DRYER ELEMENT NOT COMING ON

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life

Read More
Alina F. -
October 14, 2011
A:

Thank you for your question and I understand your concern.

If the high limit thermostat part #341195 does not measure continuity/closed then it is faulty and will need to be replaced. If the voltage is measuring 245 across the high limit, the high limit is open. Replace the high limit thermostat and your heater will likely operate again.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post. NOTE: Be sure to disconnect the power cord from the power source before replacing the high limit thermostat.

Read More
Joey S -
Sears Technician
October 15, 2011
See more answers
Q:

Kenmore electric dryer: wire overheating

A:

You've done a great job so far inspecting your dryer. Below I have attached the link to the Sears Home Services website if you would like to schedule service. I hope your issue gets resolved!

Read More
Jackie S -
April 04, 2011
A:

Thank you for your question and I understand your concern.

The wire nut and wire overheated and melted because of a faulty connection where the two wires were joined together with the wire nut. Loose electrical connections will cause high current trying to flow through the bad connection which creates heat and it eventually caused the wire nut and wire to burn up and become brittle and break apart.

Be sure to use the two new wire leads and the wire nuts that come with the replacement heating element. Make sure to cut off any of the old melted wire before re-connecting the two new wire leads to the existing wires. NOTE: Be sure to have the dryer cord disconnected from the power source before servicing your dryer.

Read More
Joey S -
Sears Technician
April 05, 2011
See more answers

Top Parts