Model #11086151100 KENMORE Residential Dryer

  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • Top And Console Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:



Question and Answers


dryer belt replacement 110.86151100


Hello glad to help.  Thank You for choosing Sears

I am sorry and do understand your frustration when you need to replace the dryer belt.

Glad to help out.   Im  looking at your model number 110.86151100.

Sorry that you didn't get instructions.  Have been with Sears forever and know that if you order just the belt then no instructions come.   I will look up the instructions for you though and hope this helps.

Instructions for belt:

1.  Unplug the dryer from the wall and have the door closed so it is latched good.

2.  Raise the lint sreen door and pull the lint screen out.  Take out the 2 screws below the lint screen and set them apart to the side in a safe place.

3.  Pry up the corners of  your dryer at the left and right edge of the front panel, using a flat screwddriver.  Lift the top about 2 inches.

4.  Pull the metal clips that are around the corners on the front panel, you'll find them just below the top using pliers.  Now you can lift the top up and lift it backwards towards the rear so you can look down and see the drum.

5.  Take out the screws on the left and right edges  to take the front panel all the way off, then the lower kick panel and put it to the side.

6.  Remove the old belt.  

7.  Slip the new belt over the dryer drum with the v shape on the down side.   Guide the belt into the grooves.

8.  Pull the belt over the motor shaft/pulley and center in the end of the shaft.

9.  Push the idler pulley back toards the motor to slip the belt around the  pulley.  Then release the pulley to restore the tension in the pulley.

10.  Pull the belt downward on one side to visually inspect the rotation of the drum, tension pulley and the motor shaft/pulley.  Check to make sure the belt is going to turn smoothly.

11.  Got the hard part done, then just put the kick panel, front panel back on and set the top back in and ready to go.

12  However for it to really work.  You must push it back to the wall and plug it in. 


If you have further questions please let me know.

Thanks for choosing Sears



Read More
Larry L -
Sears Technician
September 27, 2013

I need instructions to install new drive belt on Kenmore HD dryer Model 110.86151100. Thank you. 11086151100 Kenmore Electric dryer


Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when needing to replace the belt on your Dryer. I did look into the model number you have provided and I have found instructions that will assist you in replacing that belt. Let me know if this helps.



Thank you for your question. Have a great day.

Read More
Natasha12 -
Sears Technician
September 27, 2013

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show