Model #11082692820 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Control Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Miscellaneous Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Bleach, Detergent And Rinse Dispenser Parts
    3 Results
  • Water System Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What is the cubic feet of my kenmore Washer Model #110.82692820 ?

A:

I know how useful it can be to have more detailed information about your appliance especially if you are thinking about replacing it. While you are waiting for an expert answer, I suggest you look in your owners manual for more detailed information about your appliance. Below is a link in where you can enter your model number and your owners manual will pop up. I hope my link is useful.

Read More
Joseph P. -
January 04, 2011
A:

For this model washer would be 3.2 cubic ft.

Read More
Jerome G. - Personal Solutions Manager -
Sears Technician
January 06, 2011
See more answers
Q:

Kenmore washer 11082692820 delivers lukewarm water when set on cold

A:

Having an appliance not working properly can be quite frustrating especially when its not working on laundry day. While you are waiting on an expert to answer your question, I researched your question in the Manage My Life website and found this great link on lukewarm water on Washer. I attached the link below. Hope this helps!

Read More
Dezeray S -
November 16, 2010
A:

Thank you for a very good question. From what you described about the washer overflowing sometimes, you will need to replace the watervalve. On this model it looks like the water temperature is controlled by a thermister (temp sensor) at 70 degrees for cold water fill, this is normal.

The only way to check the thermister is with an ohmmeter. First, disconnect power to the washer. I am sending you access instructions in the attachment below. NOTE; under the console on the left side, open the small cover to access & pull off the dispenser hoses. At room temperature the thermister should read 46k ohms & at 100 degrees 28ohms.

Please see the image showing where the thermister is.

Read More
biker dave -
Sears Technician
November 17, 2010
See more answers

Top Parts