Model #11082683120 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Console Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Miscellaneous Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Water System Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washer Not Agitating or Draining 11082683120

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when there is trouble with the washer.
 
Glad to help out.   Im  looking at your Kenmore Washer model number  11082683120.
 
Items to look at:

1:  Drain hose.  Make sure they are clear and don't have any cloggs.   

2.  Pump is working?

3.  Water spout where the discharge water goes to and make sure it isn't clogged.

4.  Check the lid switch with multimeter for continuity.

5.  Between the motor and the transmission there is a coupling.   It is 2 plastic pieces with a rubber round piece in the middle.   If you see rubber parts on the floor then that is the coupler going bad.   It is what spins the tub.

Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".
 
Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.
 

Read More
Larry L -
Sears Technician
June 05, 2014
Q:

Washer won't agitate or drain 11082683120

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when there is trouble with the washer not agitation or spinning.
 
Glad to help out.   Im  looking at your Kenmore Washer model number 11082683120.

no draining and spinning of washer:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com

I am sorry and do understand your frustration when there is problems with the washer.

Glad to help out.   I'm  looking at your Kenmore Washer model number 11023812100.

Check the drain hose.  Is the drain hose kinked or clogged?  If so then you can fix the situation.

Check if there is any blockage in the drain pipe or where ever you have the drain hose connected to for the spill of the water.

Make sure the drain hose is not more than 96 inches above the floor.

1.  Was a gentle/delicate/low spin cycle selected?
These cycles of slow spinning leaves more water in the load.  To remove more water, select a cycle with a high spin speed.

2.  Were you washing a large load?
The wash load must be balanced and not tightly packed.  for it can cause reduced spin speed and wet clothes at the end of the cycle.

3.  Do you see suds with the problem?
High amount of detergent can create too many suds.  In some cases can stop the washer from pumping out water and spinning.  Follow the manufacturers recommended amount and measure it well.   If you have very soft water, use less detergent.

4.  Is the lid open?
If the lid is lifted during a cycle, the machine will stop.  To continue the cycle, close the lid and make sure the knob is pulled out.  The lid must be closed during the operation to fill the water, and then to wash,drain, rinse, and spin.

Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".

Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.


Read More
Larry L -
Sears Technician
June 04, 2014
Q:

Washer Model 11082683120Model 11082683120. In the spin cycle it made noises, then stopped working, but sill made spinning sounds. Go to Add question details.

A:

Thank You for contacting SearsPartsDirect.com. I do apologize for the delay in answering your question.

Based on the information you have provided I would recommend checking the motor coupler. The reason I say this, is because you mention you can still her the spinning sound. The motor coupler is designed to break to protect the motor from damage. The part number for the motor coupler is 285753A.

If you need further assistance, please respond below. I will be happy to assist you further. Thanks for visiting SearsPartsDirect.com

Read More
Desirea -
Sears Technician
March 25, 2014

Top Parts