Model #11082680100 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Console Panel Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Water System
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What is tub capacity of this washer? 11082680100 Kenmore Automatic washer

A:

Thank you for choosing SearsPartsDirect.com. I know how important imformation like the capacity can be. Due to the age of your washer model number 11082680100 I am unable to locate any more information than a parts list. If you have any other questions, please feel free to comment back. Thank you for choosing SearsPartsDirect.com. Have a great day.

Read More
Samantha A -
Sears Technician
March 05, 2014
Q:

manual for 11082680100

A:

Owner's manuals are always great to have. While you are waiting on an expert to answer your question, I was searching in the Sears Parts Direct website and found your diagram. I have attached the link below. Hope this helps!

Read More
Dezeray S -
March 21, 2011
A:

Thanks! It did help I previously thought it was a belt under there however it turns out there is no belt. It turned out that the tub seal was what came out of the tub ring gasket and is a little chewed up. Any idea if it is easy to replace new seal into old gasket? Cheaper than new washer though. I have in law coming over later this week to look at so I will probably order new seal. Thanks for the response!

Read More
Yankanich -
March 21, 2011
A:

Here is a repair video that shows how to replace the tub seal on this type of washer: Washing Machine Drive Tub Seal Replacement .

Be sure that you unplug the washer and shut off the water supply before beginning this repair.

This is an advanced procedure. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

If you need more help, reply with additional details and an updated model number for your washer. The model number that you submitted appears to be slightly off. The above answer is based on a typical Kenmore washer that begins with model number 110.826 . . .

Read More
Lyle W -
Sears Technician
March 22, 2011
See more answers
Q:

No power to washer mixing valve.

A:

I understand your having problems with your Kenmore Washer. I found a website under Google that might be able to give you some useful information. While your waiting on an expert answer you can take a look at the link I attached below. I hope this helps!!!!

Read More
Raquel F -
July 30, 2010
A:

If the hot water is the only problem and it will fill with cold then the water level switch is most likely okay.

You say there is no current to the valve but you don't make clear how this was checked. If there is no current then the water temperature switch is most likely at fault but there is an ETC control which might also be part of the problem.

Coming off the temperature switch should be a Brown wire with red tracer and this should go to the hot water valve. This wire should have current or the switch is bad.

One trick to checking this problem is to swap the wires from cold valve to hot valve. If cold water is working then when switch to the hot water terminals there should be hot water unless the valve is bad.

The inlet valve 285805 is about $27 dollars, the 388246R control is about $57 dollars and the 388291 temperature switch is about $20 dollars. All can be obtained from the following link: Sears PartsDirect .

If there is no hot water in any setting I suspect the valve is the problem.

The image below will show you how to raise the console and remove the cabinet to check these parts. Remember to unplug the washer first.

Read More
Fred M -
Sears Technician
July 31, 2010
See more answers

Top Parts