Model #11082670100 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous Parts
    3 Results
  • Console Panel Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Water System Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

What is wrong if the washer won't rinse AND it won't allow cold water to enter? 11082670100 Kenmore System 21 automatic washer

A:

Thank you for your question.  I am sorry about the problem with your Kenmore 110.82670100 Top Load Washer.  Since the Rinse cycle fills with cold water if the cold water valve does not work then likely the Rinse cycle will not work.  If you have a meter then the place to start is checking voltage on the violet wire on the water level switch.  If there is no voltage the timer is likely at fault.  If there is 120 volts then the water level switch or valve is likely broken.  If empty the water level switch should show a circuit between the violet and pink wires.  The usual suspect would be a bad Water Valve.  If a meter is available then you can check voltage to the water valve to confirm it is bad.  The image below shows how to raise the console and remove the cabinet to access the water valve.   I hope this helps.  You can reply below with any additional details for further assistance.  Thank you for using Manage My Life. 

Read More
Fred M -
Sears Technician
October 07, 2013
Q:

What is wrong with a Kenmore model 110.82670100 washer when it will wash but it won't drain or spin?

A:

If the model 110.82670100 washer will agitate then the motor is most likely okay. If the washer will agitate but will not drain or spin then the most likely cause of this problem is a bad lid switch.

The pump can also be the cause but the first thing I suggest you check is the lid switch especially if the motor appears dead.

A motor that is humming or trying to turn but can't might indicate a sock in the pump jamming it.

The image below will show you how to remove the cabinet to access the lid switch and motor/pump. Remember to unplug the washer first.

The 279347 lid switch is available from the following link: Sears PartsDirect .

The switch can be checked with a volt/ohm meter if you have access to one and are comfortable using it. The image also shows how to bypass the lid switch and run the washer. Use extreme caution if you try this.

I hope this information is helpful to you but submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
January 19, 2010

Top Parts