Model #11082467830 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Console
    3 Results
  • Water System
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch Gearcase, Motor And Pump
    3 Results
  • Machine Base
    3 Results
  • Wiring Harness
    3 Results
  • Gearcase
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

The center dial on my Kenmore washer 11082467830 seems stripped out. It works when pushed in or pulled out to start/stop water, but won't grab to set load.

A:

An expert shall have a response for you within 24 to 48 hours. Have a wonderful new year!

Read More
Alina F. -
December 31, 2010
A:

Thank you for question and I understand your concern. Based on your symptom and details, the timer will need to be removed and replaced.

In order to remove and replace the timer:

  • Disconnect the power cord from the power source.
  • Push the timer knob in and turn it counterclockwise (CCW) to remove the knob. If the metal shaft is spinning with the knob, hold the dial stationary while spinning the knob CCW.
  • Remove the knob and then slide the dial off.
  • Remove the two screws hidden by the dial.
  • Remove the each screw located at the bottom of each console end cap.
  • Slide the console towards the front and lift it up and hinge it over the rear panel.
  • Disconnect the quick disconnect from the timer.
  • Reverse the procedure to install the new timer.

The timer is part #661549 and is available at Sears Parts Direct .

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
January 03, 2011
A:

The load will start, and advance, you just have no way of knowing what setting you are starting on. I was thinking it was just the knob or the dial?

Read More
river betty -
January 03, 2011
A:

River Betty: Based you your symptom and details, the timer will need to be replaced even though it will start and advance. The knob is not likely stripped, the stem inside is likely slipping within the cam inside the timer. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: [Sears Home Services | http://services.sears.com/shs/category/repair] .

Read More
Joey S -
Sears Technician
January 04, 2011
See more answers

Top Parts