Model #11082407120 KENMORE Residential Washers

  • Top And Cabinet Parts
    3 Results
  • Console Parts
    3 Results
  • Meter Case Parts
    3 Results
  • Rear Panel Parts
    3 Results
  • Agitator, Basket And Tub Parts
    3 Results
  • Miscellaneous Parts
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump Parts
    3 Results
  • Machine Base Parts
    3 Results
  • Wiring Harness Parts
    3 Results
  • Brake And Drive Tube Parts
    3 Results
  • Gearcase Parts
    3 Results
  • Water System Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I replaced the timer in my Kenmore Coin Operated Wash Machine and now the washing time has increased from 35 minutes to 55 minutes.. Want old time.

A:

Managemylife.com is always a great resource to find the answers to just about anything. I know this information can be very helpful for you to have. While you have been waiting for your expert to respond, I did some research but I was unable to locate information that would be helpful with regards to your question at this time. Your expert will be answering you within two business days but usually sooner.

Read More
Anna T -
January 14, 2013
A:

Hi,

Thank you for asking this question and allow me to answer it this way.

The timing motor run different cams and the number of legs on the cams determine the length of time in the dry cycle. Here is a manufacture of the cams and if you contact Greenwald they will assist you in getting the correct cam for the time you want.
GREENWALD INDUSTRIES 212 Middlesex Avenue l Chester, CT 06412 USA l Tel: (860) 526-0800 l Fax: (860) 526-4205 Toll-Free Tel: 1-800-221-0982 l Toll-Free Fax: 1-800-445-1340 www.greenwaldindustries.com United States & Canada Customer Service & Technical Assistance: Monday�Friday, 8am to 5pm EST. Contents, specifications and availability are subject to revisions serving the technical improvement.

I hope this answer is useful and that it helps you correct the problem with your appliance.
Thank you for using ManageMyLife.

Read More
Bill__W -
Sears Technician
January 16, 2013
A:

Hi Thanks Bill..I will give them a call.. Karl

Read More
Karl -
January 16, 2013
See more answers
Q:

What is wrong with a Kenmore model 110.82407120 washer when the agitator is not at full power and the drum does not spin during the rinse cycle?

A:

If the washer will fill and agitate then the motor is most likely okay.

When an older Kenmore washer will fill and agitate but will not drain or spin then the most likely cause of the problem is a bad lid switch. You will want to make sure the lid switch is being actuated when the lid is closed. A broken actuator can also cause this problem.

If the washer will fill, agitate and drain then the lid switch is most likely okay. If the washer will drain but not start a spin cycle then the problem can be with the timer or clutch/basket drive.

If the washer will drain but not start a spin then try lifting the lid for a moment and then close it and see if the spin will start. If it does then there is no pause from the timer to start the spin cycle.

A weak agitation can be caused by a stripped agitator or a loose screw holding the agitator. If the motor is running but there is no good agitation then the transmission might be the problem.

From the description you give I'd start with the 279347 lid switch or submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
January 14, 2010

Top Parts