Model #11082382100 KENMORE Residential Washers

  • Top And Console Parts
    3 Results
  • Drive Parts
    3 Results
  • Water Pump Parts
    3 Results
  • Tub And Basket Parts (non-suds Only)
    3 Results
  • Tub And Basket Parts (suds Only)
    3 Results
  • Water System Parts (suds Only)
    3 Results
  • Cabinet Parts
    3 Results
  • Miscellaneous Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Washing machine drains before washing 110-82382100

A:

I can see how this would be frustrating to just watch the washer fill and drain. While you wait for the expert to review your model, you might check the two links below with similar questions. I hope these are helpful.

Read More
Barbara -
November 17, 2012
A:

what were the two links? They did not show in your response.

Read More
frank -
November 18, 2012
A:

Thank you for your question and I understand your concern.

The likely failure is either a faulty control magnet/wig-wag assembly located on top of the gear case. It will have a red, yellow and two white wires attached to it. It could have a faulty coil, bent plunger or a worn cam slide. Many of the parts are no longer available for this older belt drive Kenmore washer. The wig-wag/magnet assembly is just one of the parts that is no longer available. Your best bet is to start looking for a new washer. The coil with the yellow wire is the one that controls the drain pump. The slide moves the lever on the pump one way or the other. One way it pumps out, the other prevents it from pumping out.

I added images below that may be helpful. I strongly suggest replacing the washer rather than attempting to repair it. Once a washer of this age begins acting up, it will never be reliable.

Read More
Joey S -
Sears Technician
November 19, 2012
See more answers
Q:

Need to clean black greasy material leaked from old Kenmore Washer

A:

I understand how important it is to clean the the gunk that was left behind from your washer, after twenty five years i am sure the floor is pretty stained. While you are waiting for an expert answer, I did manage to find two links that will provide you with more information about your problem. I hope my links are useful.

Read More
Joseph P. -
October 12, 2010
A:

Start out by using cat liter or sawdust to rid most of the liquid.

"Simple Green" is non - toxic and biodegradable, it's available at any hardware store, or garden shop....or "Gunk," at the Automotive store, which is not biodegradable. I would use the Gunk first, then scrub it down with liquid soap, like Palmolive for dishes....it works too. Rinse it about 4 or 5 times, especially if you have pets or kids out there. You don't want any of that stuff to be eaten by the pets...or children....

Or try cat liter after the oil is gone use cola Pepsi or Coke on the spot that will get it out.

One thing I have used with great results on a number of grease and oil stains is a product called "Greased Lightening" available at Walmart or hardware stores. Spray it on stain and allow to soak, add a bit of water and scrub with a bristle brush, then wash away with hose. Good Luck!

Read More
biker dave -
Sears Technician
October 13, 2010
See more answers

Top Parts