Model #11082082800 KENMORE Residential Washers

  • Top And Console Parts
    3 Results
  • Drive Parts
    3 Results
  • Pump Parts
    3 Results
  • Tub And Basket Parts
    3 Results
  • Water System Suds Only
    3 Results
  • Cabinet Parts
    3 Results
  • Brake And Clutch
    3 Results
  • Gearcase/transmission
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

my 80 series washer (1980'S) model 110.82082800 How do I know if I have a bad timer.Now the motor sounds funny and the timer seems to be going out.

A:

I understand how important the timer is for your washer, and its important to get the part installed correctly so that it will work properly. While you are waiting for an expert answer, I recommend you resubmit your question including the full model number witch should be eight to thirteen numbers long so that the expert will provide you with a detailed answer. I did manage to find a link in where you can enter your model number and a parts list diagram will pop up with part numbers and prices. I also manage to find a link in where you can set up an technician visit and you will get an estimate of the price.. I hope my links are useful.

Read More
Joseph P. -
July 12, 2011
A:

Thank you for your question and I understand your concern.

Just to let you know that you have an older belt drive washer in which many parts are no longer available. It is not likely worth attempting to repair your washer.

There could be one of many failures causing your symptom. It could be transmission failure, timer or locked up drain pump.

Based on your description it sounds like the drain pump has seized/locked up and the drive belt is tight enough to prevent the motor from running and the motor is overheating and shutting off on the motor thermal overload. This is why the motor will not operate until it cools and the thermal overload resets. You could try this: Disconnect the power cord and remove the back panel. Grasp the belt and move it left and right while pulling it towards you to add tension and sometimes the drain pump will free up and the motor will operate again until the drain pump seizes up again. If it begins operating again then the drain pump should be replaced.

I highly recommend calling a service technician to diagnose and repair your belt drive washer.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 14, 2011
See more answers

Top Parts