Model #11081862100 KENMORE Residential Washers

  • Top And Cabinet
    3 Results
  • Rear Panel
    3 Results
  • Agitator, Basket And Tub
    3 Results
  • Miscellaneous
    3 Results
  • Brake, Clutch, Gearcase, Motor And Pump
    3 Results
  • Wiring Harness
    3 Results
  • Machine Base
    3 Results
  • Console Panel
    3 Results
  • Brake And Drive Tube
    3 Results
  • Gearcase
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Why does the water continue to come into my Kenmore model 110.81862100 washer after the machine has shut off?

A:

From the description you give most likely the water valve is the problem.

The timer is also capable of causing this error but if the timer was putting 120 volts to the valve it would be filling normally and not filling slowly.

Most likely the valve is not shutting off all the way and allowing the slow fill to continue.

One easy test you can do is to unplug the washer after if shuts off. If the water continues in with the washer unplugged then the valve has failed. If the water shuts off when you unplug the washer then most likely the timer has failed.

I'd recommend you replace the 285805 inlet valve which can be obtained from the following link: Sears PartsDirect .

The image below will show you how to access the valve if you don't mind a little do-it-yourself project to save the cost of a repairman. Remember to unplug the washer first.

I hope this information is helpful to you but submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 07, 2009
Q:

Why won't my washer drain or spin?

A:

You did not indicate if the motor is running during the drain or spin cycle. I'm going to assume that the motor only runs during the agitate cycles only.

Most likely the safety lid switch or the lid switch actuator is broken. If the lid switch is not being energized and closed when the lid is shut the motor is not going to run at all during spin and drain cycles. Check under the bottom of the lid to confirm that the lid strike is still attached to the lid.

Open the lid and look down the little opening where the lid strike would insert into to trip the lid switch to see if the actuator is broken. In order to gain access the lid switch to replace it the washer cabinet must be removed.

I recommend calling a service technician to diagnose and repair your washer.

Read More
Joey S -
Sears Technician
May 07, 2008

Top Parts