Model #11077974830 SEARS Laundry Appliances Division (26)

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Asm
    3 Results
Find part by diagram >

Question and Answers


How do I replace the door cord on my Kenmore #110.77974830 gas dryer.


Use a putty knife to press in & release the spring clips holding the top of the toe panel in place & remove the toe panel. Open the dryer door & use a small screwdriver to pry off the plastic plugs on the door section securing cables in place; these are keyhole slots. Place new cables in the exact same place as the old cables & lock the plastic plugs back in place. Route the cables through the holes in the front panel & close the door. Attach the other end of the cable to the door springs & the springs attach to the lower frame. Be sure the cables are in the slots of the plastic cable guides before closing up the lower panel.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
May 06, 2010

Top Parts