Model #11077974400 SEARS Laundry Appliances Division (26)

  • Top And Console Assembly
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Why is my gas dryer not heating?

A:

Thank you for a very good description of the findings & symptoms. The 2 wires connected to the flame sensor will not matter what connector they are on. This device is a switch that is either open or closed. We know the flame sensor is good because the igniter comes on & glows. You actually pointed out the answer to your question when you stated that the igniter comes on for about 10 seconds & then cuts off. This symptom would indicate that either the gas to the dryer is turned off or the gas valve coils are weak. If you’re sure the gas supply is on, I would recommend replacing the gas valve burner assembly.

Read More
biker dave -
Sears Technician
September 17, 2008
Q:

What is the composition of the igniter wiring harness?

A:

The wiring harness of the igniter is made up of 3 components; center is copper wire, 1st layer is plastic, 2nd layer is braided fiberglass.

Read More
biker dave -
Sears Technician
September 17, 2008

Top Parts