Model #11077965610 SEARS Laundry Appliances Division (26)

  • Top And Console Parts
    3 Results
  • Cabinet Assembly
    3 Results
  • Bulkhead Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Is there an electrical schematic available for my dryer (bulkhead assembly?

A:

I understand that your dryer has not heat. I have taken some time to research your question here on the Manage My Life website and I noticed that someone else had asked a similar question with a posted response from an expert. You can also visit Sears Home Services website to set service with a Sears technician. I have attached the links below. Hope this helps!

Read More
Dezeray S -
July 04, 2011
A:

The wiring diagram for that dryer was available on micro-fiche. I provided an image of that wiring schematic in the image below. This dryer has two operating thermostats and a safety thermostat. Try the dryer to see if the igniter will glow using either heat setting. If not, then your likely failure is in the high limit thermostat, the flame sensor or the ignitor. You can view a parts list diagram and order parts on the Sears PartsDirect website.

NOTE: Be sure that you unplug the dryer and shut off the gas supply before accessing internal components.

This information may help you with your dryer failure. If you need more assistance, reply with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
July 05, 2011
A:

I was not able to get the ignitor to glow in either the low or high settings. I did verifiy that the thermal fuse and thermostat(s) are good. Does this gas dryer have a pilot light or an automatic ignition system? If it has a pilot light, then somehow it went out and needs to be relit. This is an old dryer from around 1979 so I thought it might have a pilot light. Unfortunately, I do not have any manuals. Not sure how to proceed at this point

Read More
gary -
July 06, 2011
A:

The theory of operation for the gas valve assembly is shown in the image below. The igniter should fade off after heating up as described below. If the igniter does not cycle off so that the current flows through the gas valve coils so that the valves open and the burner ignites, then you could have a bad flame sensor or a weak igniter. If the igniter glows and fades off but the valves do not open then you may have bad gas valve coils. Your first step in troubleshooting this current problem is to determine why the igniter is not glowing in the first place. You could have a bad igniter, a failed flame sensor, a bad high limit thermostat or some other problem in the circuit shown above. You can check the continuity through components in that circuit using the procedure shown in the link below. This may help you determine the cause of you problem. If you need more help, reply with additional details.

Read More
Lyle W -
Sears Technician
July 07, 2011
See more answers

Top Parts