Model #11077876100 SEARS Laundry Appliances Division (26)

  • Top And Console Assembly
    3 Results
  • Cabinet Assembly
    3 Results
  • Bulkhead Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore dryer heats up once every time, but then stops heating. Is this thermostat?

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide a little more information such as the make and complete model number of your product so your expert will be able to research and provide you the best possible answer. Continue this existing thread. Just log back into the website, go to your profile and find your question you asked and then click on join the conversation  and  provide that information. This will speed up the process for you and save you some time.

Read More
Dezeray S -
July 08, 2013
A:

I should have mentioned that most of the dryer questions I searched for looked like they were geared towards dryers that weren't heating at all. Also, here's what my gas thingy looks like behind the front lower panel.

Read More
Mandy -
July 08, 2013
A:

Thanks Dezeray! I included the information in the picture provided. Sears makes it difficult to decipher the model number so I just took a picture and included it in the original post.

Read More
Mandy -
July 08, 2013
A:

Thanks for contacting manage my life about your dryer model 110.77876100; sorry you are having a problem, I will be glad to assist you. Based on your explanation of the issue I do not think you have a thermostat issue, because if the thermostat was bad the dryer would not be calling for heat (igniter going on and off) _Always disconnect power supply before servicing the appliance and when testing live voltage be sure to wear proper safety equipment (gloves and eye protection) also be aware of sharp metals on product_I suspect that you may have a bad sensor and I have attached directions below that guide you through checking the sensor and igniter as well as the valve coils. You will need a high quality volt/ohms meter to test correctly and a basic knowledge of electrical circuits and use of the meter.  (NOTE if you need parts here is a link do not use parts numbers listed on attachments as they may differ from your exact model)  I hope this helps, if you need more help reply with details and I will be happy to respond. If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.Ron H.

Read More
Ron H -
Sears Technician
July 09, 2013
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show