Model #11077832791 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Dryer does not work rite

A:

Troubleshooting a dryer can be challenging. I was able to locate two similar questions that has information that may help while you wait for the expert. I attached the links below. I hope this information helps.

Read More
Barbara H. -
April 21, 2012
A:

The timer was a good try and I'm sorry it didn't work. The next suspect would be the push to start switch. It can be checked for an closed circuit when the button is pressed and an open circuit when the button is released. Another way to verify the push to start is the problem is to unplug it after the dryer is start. This should only be attempted by a technician so no one gets shocked. I hope this information is helpful to you. You can reply with any additional details or questions for further assistance.

Read More
Fred M -
Sears Technician
April 21, 2012
See more answers
Q:

What causes the burner in my Kenmore dryer to cut off prematurely?

A:

From what you’re describing it sounds like weak burner coils. If the burner comes on when you start the dryer initially but does not come back on during the cycle I suspect the gas valve coils are weak & need to be replaced; part number 279834. www.searspartsdirect.com Other possibilities; flame sensor, gas valve or thermostat. Please see the images provided below for access & step by step repair instructions.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
April 12, 2010
Q:

Why is my Kenmore gas dryer running but not heating?

A:

I’m sorry; our imaging is down today. The igniter is in the front area & the other components are in the back behind the back panel. Pull the lint screen out & remove those 2 screws. Release the front clips with a putty knife & lift the top up to access the front panel screws & remove the front panel by lifting slightly. Release the belt taking note of it’s & the idler pulleys location. In the back you will find the thermal fuse & operating thermostat on the blower housing & the hi-limit on the heater housing. All should show closed.

Be sure to use extreme caution when working with live voltage.

Read More
biker dave -
Sears Technician
August 06, 2009

Top Parts