Model #11077732795 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
  • Burner Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore Dryer Model 110.77732795 Issue

A:

I understand how frustrating it can be to have a dryer running intermittently. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina F. -
April 20, 2012
A:

From the description you give I suspect the motor is the problem. If the motor shuts down but will work again when it cools down then likely the motor is the problem. I would suggest you raise the top panel and remove the front panel and drum to check for lint build up over the motor. Lint covering the motor will cause the motor to overheat and shut down. Lint can be cleaned out by using a vacuum hose extension. The image below will help you remove the front panel and drum. Remember to unplug the dryer first.

Read More
Fred M -
Sears Technician
April 21, 2012
See more answers
Q:

Kenmore dryer model 110.77732795. Tumbling and air blowing but no heat. Cleaned lint off everywhere. What do we check next.

A:

Hello, I can understand your concern. I would be a little irriated if my dryer wasn't working properly. I think I might have found some suggestion that will answer your question. I have attached the link below. I hope this helps.

Read More
Flo R -
June 26, 2010
A:

Thanks FloR, this gives me a few more things I can check. It was helpful.

Read More
rockyangel -
June 26, 2010
A:

All of the components wired and connected in series between the red wire on the timer and the blue wire connected at gas valve will need to be disconnected and checked for continuity. NOTE: Disconnect the power cord from the power source before removing the rear panel and front panel.

You will need to disconnect and test the following components for continuity:

  • Hi Limit
  • Operating thermostat
  • Thermal fuse
  • Flame sensor (accessed from front)
  • Ignitor (accessed from front)

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
June 29, 2010
A:

I am having the same issue. I checked all of the things above and everything checked out except for the igniter which measure around 60 ohms. Does this mean it is the issue

Read More
noe -
November 09, 2011
A:

on a 12 yr old dryer when everything works except no heat,what is the most likely cause?i'm thinking igniter or fuse and can just a fuse be replaced as i didnt see a fuse being offered as a kenmore part.

Read More
doug -
January 16, 2012
See more answers
Q:

dryer not get heat, HELP

A:

A dryer that is not heating properly sounds like a waste of electricity and I will be happy to help. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assistance for you.

Read More
Joseph P. -
December 28, 2011
A:

Hi Elaine,

Thank you for submitting a question to Manage My Life.

Here is a link to a previous question that I answered on this type of dryer with the same issue; Click Here . In my answer I cover the first things you need to check.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Here is a link that you may use to view the parts list diagram or to purchase any parts needed; Sears Parts Direct .

I hope this is helpful. Check the things I have covered here, and if I may be of further assistance, include more details, in a reply to this post.

Landell

Read More
Landell -
Sears Technician
December 29, 2011
See more answers

Top Parts