Model #11076924501 KENMORE Residential Dryer

  • Top And Console Parts
    3 Results
  • Cabinet Parts
    3 Results
  • Bulkhead Parts
    3 Results
  • 8576353 Burner Assembly, Optional Parts (not Included)
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Removing dryer top to access door switch. Kenmore elite Model 110-76924501. - The end covers and steel back panel are different from previous answer.

A:

I am sorry that you are having some difficulties with your dryer and I will be happy to help. I did some research and I was able to find a link that will provide you with some good information. I hope this helps with your repairs while you wait for your expert response.

Read More
Joseph P. -
October 02, 2012
A:

Based upon the model number 110-76924501 this is a Dott dryer which is serviced from the front. The image below may help you remove the front and top panel. Remember to unplug the washer first. I hope this helps. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 03, 2012
See more answers
Q:

Lifting elite dryer 110-76924501 top cover off to access defective door switch.

A:

Having a properly working dryer is very important. I did some research on your model number but was not able to find an answer to your question. Your expert will be able to help give you a detailed answer to help you. It may take 24-48 hours. I do hope that everything works out on the dryer.

Read More
Marc -
October 01, 2012
A:

I know that it can be very difficult to replace parts at times. To replace the door switch:

  1. Disconnect the power cord from the power source.
  2. Place the console in the service position by removing the left and right hand end caps. See last image below.
  3. Remove the screw located under the end cap trim
  4. Lift the console and hinge it over the rear panel.
  5. Remove the screws as shown in the first image and remove the top.
  6. Disconnect the lid switch harness.
  7. Remove the screw securing the door switch and remove the door switch.
  8. Reverse the procedures to replace and reassemble the dryer.

I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
October 02, 2012
See more answers
Q:

How o lift top to replace door switch on elite dryer 110-76924501?

A:

Replacing a part on a dryer can be pretty difficult without the proper instructions. I did some research on the subject and provided a link, I hope this will be helpful until an expert responds to your question. The link is attached below.

Read More
Yadira B -
October 01, 2012
A:

I know that it can be very difficult to replace parts at times. To replace the door switch:

  1. Disconnect the power cord from the power source.
  2. Place the console in the service position by removing the left and right hand end caps. See last image below.
  3. Remove the screw located under the end cap trim
  4. Lift the console and hinge it over the rear panel.
  5. Remove the screws as shown in the first image and remove the top.
  6. Disconnect the lid switch harness.
  7. Remove the screw securing the door switch and remove the door switch.
  8. Reverse the procedures to replace and reassemble the dryer.

I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
October 02, 2012
See more answers

Top Parts