Model #11076904690 KENMORE Residential Dryer

  • Top And Console
    3 Results
  • Cabinet
    3 Results
  • Bulkhead
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to replace wheel blower on Kenmore gas dryer.

A:

Parts that do not seem to fit once you are in the middle of a repair can be upsetting. The expert will review and respond within 24-48 hours if not sooner.

Read More
Barbara H. -
May 13, 2011
A:

Hi Barbara, you can say that again, I was so happy to be finnally getting this done and then BUMP, lol. But hopefully things will all work out. Thanks.

Read More
Darryl -
May 13, 2011
A:

I believe the images below will help you complete this project.

Give me a reply if things still won't go together.

Read More
Fred M -
Sears Technician
May 14, 2011
A:

Hi Fred the drawing are great and very helpful. But I still need help with removing the fitting from the motor rod for the blower wheel, if it even comes off. Please examine my photes again to see the problem. The inside of the new blower wheel in to small to fit over the motor rod with that fitting over it. Buttom line, does the fitting come off without damaging the motor rod?

Read More
Darryl -
May 21, 2011
A:

The part on the shaft is not suppose to come out of the blower wheel. You will need a pair of vise grips to remove this piece. It will have to be muscled off. One per to hole the shaft and one person to turn the piece may be the best solution. It is a reverse thread will will need to be turned clockwise to remove.

Read More
Fred M -
Sears Technician
May 23, 2011
A:

Greetings Fred, You are the men! I know you already know that but I wanted to tell you again! LOL! Your additional information was dead on. After several hours and bolt loosener and tugging clockwise I finnally got the piece off. I installed the new wheel blower and the dryer is quiet and hotter then before, just like new. Many thanks for your expert advice and all the money you saved my family. God bless you and have a great holiday weekend!

Read More
Darryl -
May 23, 2011
See more answers
Q:

How do I replace a thermal fuse on a Kenmore gas dryer model 110.76904690?

A:

If the dryer is running but not heating then the thermal fuse is the place to start. If the dryer is not running then the thermal fuse is not the problem.

The image below contains the wiring diagram for your dryer and it may be helpful resolving this problem.

The thermal fuse will prevent the dryer from heating but it will not prevent the dryer from running.

The thermal fuse can be checked by removing the lower access panel. See the 2nd image for a picture of this. Remember to unplug the dryer from power first.

The fuse can be checked without an ohm meter if extreme caution is used. To check the fuse you remove the two wires on the thermal fuse and join (jump) them together with a small piece of wire. Put a little electrical tape around the connection and don't let it touch any metal. The carefully start the dryer and see if it heats. If it heats then replace the thermal fuse immediately.

Don't continue to run the dryer to catch up on laundry with the fuse jumped. It is a safety feature and while it is okay to jump around it for a moment it is not okay to continue to use the dryer with the fuse jumped.

I hope this information helps to resolve this problem with the dryer. You can submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
August 05, 2009

Top Parts